Thank you for purchasing the DOME
On/Off Plug-In Switch, which works with your
Z-Wave Certified Controller to turn on and off
any plugged in electronic device and monitor its
power consumption.
SolidWorks Student Edition.
For Academic Use Only.
Connect Button
DEVICE PORT
PLUG
Including/Connecting into the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller
to enter inclusion mode.
When prompted by the Controller:
1. For proper inclusion, bring the On/Off Plug-In Switch
to within 10 feet of your Controller and plug it in. After
inclusion, the device can be moved to any desired
location.
2. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating inclusion.
Excluding/Disconnecting from the Z-Wave Network:
Follow the instructions for your Z-Wave certified Controller to
enter exclusion mode.When prompted by the Controller:
1. Plug in the On/Off Plug-In Switch within range of your
Z-Wave Controller.
2. Press the Connect Button quickly 3 times in a row.
The LED Indicator will flash five times indicating exclusion/dis-
connection.
Resetting the On/Off Plug-In Switch to Factory Default
Settings:
To disconnect from the Z-Wave Network and restore factory default
settings:
1. Plug in the On/Off Plug-In Switch.
2. Hold the Connect Button for 10 seconds until the LED Indicator
blinks once, then release the button.
Only do this if the controller is disconnected or otherwise unreach-
able!
Overload Protection:
The On/Off Plug-In Switch shuts off power and the LED Indicator
will turn red when a current higher than 13 Amps passes through.
To restore power after a current overload, power cycle the plug
either by pressing the physical button or through your Z-Wave
controller. You can also reboot the plug by unplugging it from the
outlet.
On/Off Plug-In Switch
