background image

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600     |     Fax: 02 9554 9433

enquiries@domuslighting.com     |     www.domuslighting.com

Installation Manual

Specifications

Voltage:

240V AC

Lumen (±5%): 2000lm

Dimmable:

No

Power:

30W

Beam Angle:

115

°

CRI:

≥80

IP Rating:

44

CCT: 

5000K

Lifespan:

40,000hrs

Note: 

 -The lamp must be installed by professional electrician

 

-Ensure the power supply is switched off before fitting this product

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

MURO-30S

Order Code

Product Code

Description

25022

MURO-30S-B-W

30W Spotlight with sensor, Black Die Cast Aluminium. White 5000K

25023

MURO-30S-S-W

30W Spotlight with sensor, Silver Die Cast Aluminium. White 5000K

25024

MURO-30S-W-W

30W Spotlight with sensor, White Die Cast Aluminium. White 5000K

Thank you for purchasing your new LED MURO-30S, Please take the time to read and understand the instruction 

sheet below. Failure to do so may void warranty.

Introduction

The LED Light incorporates a PIR (Passive Infra Red) sensing device which continuously scans a preset operating 

zone and immediately switches the light on when it detects movement in that area.

This means that whenever movement is detected within the range of the sensor the light will switch on 

automatically to illuminate pathways, steps, patios, porches, or whatever area you have selected to light for 

reasons of safety, convenience.

While there is movement within range of the unit the light will remain on.

While to fit your LED lamp

 To achieve best results, we suggest you take into account the following points:

•  Ideally the LED lamp should be mounted 1.8 to 2.5 metres (6 to 8ft) above the ground to be scanned 

•  To avoid damage to unit - do not aim the sensor towards the sun.

•  To avoid nuisance triggering, the sensor should be directed away from heat sources such as barbecues, Air  

  conditioners, other outside lighting, moving cars and flue vents.

•  To avoid nuisance triggering, keeping away from the area of strong electromagnetic disturbance.

•  Do not aim towards reflective surfaces such as smooth white walls, swimming pools, etc. The LED lamp    

  scanning specifications (approximately 12 meters at 180°) may vary slightly depending on the mounting height  

  and location. The detection range of the unit may also alter with temperature change. Before selecting a place  

  to install your LED lamp you should note that movement across the scan area is more effective    

 

  than movement directly toward or away from the sensor. If movement is made walking directly towards or  

  away from the sensor and not across, the apparent detection range will be substantially reduced.

Installation

•  Switch power off at the meter box and ensure that there is no power to the lamp.

•  Unscrew the screws on the main body, remove the backcover.

•  Remove the Cable Anchorage and connect the cable to the Terminal Block.

•  Use the back cover to mark the position of screw holes onto mounting surface. Drill the wall to depth of about  

  3cm and fit the wall plugs (supplied), then fix the support to the mounting surface with the screws. Care    

  should be taken to avoid drilling or screwing into concealed electrical wiring.

•  Re-place the Cable Anchorage.

•  Fit main body onto the backcover. Adjust the light direction desired and tighten the screws.

•  Switch the main power back on.

Reviews: