WN 059725 45532 – 2018-11
EN
STV 50x
Mounting instructions
Contents
Disassembly, recycling and disposal
1
About this document
1.1 Contents and purpose
This document describes the mounting of the
electromechanical locking device STV 50x and the
connection to a SafeRoute® system.
1.2 Target group
This document is intended for assembling technicians
and specialists authorized for mounting by
dormakaba.
1.3 Other applicable documents
The following documents belong to the unit’s
complete documentation and must be observed:
• The SafeRoute® system manual
• The respective door unit’s inspection log
1.4 Documents storage
This document must be handed over to the facility
operator after mounting and commissioning.
1.5 Symbols used
1.
2.
Sequence of action steps
6
Reference to a chapter
Door opening direction DIN left =
opening outwards to the right
Door opening direction DIN right =
opening outwards to the left
Components may be damaged by
electrostatic discharge. Ground
your own body before touching a
component!
2 Safety
2.1 Intended use
The STV 50x is an electromechanical locking device
based on the quiescent current principle.
2.2 Requirements for fire and smoke
protection doors
When mounting the STV 50x in preventive fire
protection, the fire and smoke protection doors’
properties must not be impaired. Mounting is only
permitted if the proof of usability for the fire and
smoke protection door allows for installation and the
proof of usability’s stipulations are observed. Further
information can be found in the report “Permissible
changes and additions to fire protection closures”
from the Deutsches Institut für Bautechnik (DIBt
1/1996), Berlin.
2.3 Personnel qualification
Mounting may only be carried out by persons
authorized by dormakaba.
