1
High Impact Resistant Rubberized Housing
300 AMP Jump Start System
260 PSI Air Compressor
12 Volt Power Station
WELCOME
This product has been carefully engineered and manufactured to give you dependable operation. Please read this manual
thoroughly before operating your new product as it contains the information you need to become familiar with its features
and obtain the performance that will bring you continued enjoyment for many years. Please keep this manual on file for
future reference.
IMPORTANT
PRIOR TO USE, READ AND UNDERSTAND ALL WARNINGS, CAUTIONS AND INSTRUCTIONS INCLUDED IN THIS INSTRUCTION
MANUAL, AND THOSE PUBLISHED BY YOUR VEHICLE BATTERY MANUFACTURER AND MANUFACTURER OF ANY DEVICE
INTENDED TO BE USED WITH THIS UNIT. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
LOCATION OF CONTROLS
1. 12-volt DC Power Socket
2. Rubberized handle
3. Jump-Starter ON/OFF Switch
4. Battery Indicator LEDs
5. Power/Polarity Indicator
6. Charging Indicator
7. Charging Jack
8. Battery Status Button
9. Heavy-Duty Jumper Cables
10. Battery Cable Clamp Storage Posts
11. Air Inflation Hose Storage Slot
12. Air Compressor ON/OFF Switch
13. Air Compressor Gauge
14. Air Inflation Hose
15. DC Charging Cable
16. Air Inflation Nozzles
17. AC Charger
FIRST AID:
Make sure fresh water and soap are available nearby in case battery acid contacts skin, eyes or clothing. If contact with
battery acid occurs, rinse immediately and thoroughly with water. Then wash with soap and water. Obtain immediate medical
attention if redness, irritation or pain is present. For eye contact, flush eyes for at least 15 minutes and obtain immediate
medical attention.
CAUTIONS:
•
Never work alone with this product. Make sure that someone is available to give assistance if needed.
•
Wear complete eye and clothing protection. Do not touch eyes while working near battery.
•
Always keep the clamps in their storage covers to prevent sparking when they are not in use.
•
Do not recharge product battery with damaged chargers. Replace chargers immediately.
•
Do not attempt to remove or replace the battery used in this device. When the battery has reached the end of it’s useful
lifetime, take the entire unit to a battery recycling facility.
•
Avoid dropping metal tools onto vehicle battery. It may spark or short-circuit the battery or other electrical part that may
cause short circuits or explosion.
•
For proper and safe operation of the 12 Volt DC power accessory outlets, do not place anything into it except the plug of
Model No. DPS300
300 AMP BATTERY JUMPER WITH 260PSI AIR COMPRESSOR
1
4
5
6
7
8
2
3
12
10
9
11
13
14
15
17
16
