PACKAGE CONTENTS:
• Stereo Grip
• M2 Media Card Reader
• User’s Guide/Warranty Card
• Registration Card
HOW TO SET-UP THE STEREO GRIP:
1. Open the battery compartment located on the back of the Stereo Grip.
2. Install 2 “AAA” batteries and replace the battery compartment lid.
3. Unwrap the built-in cable located on the front left of the Stereo Grip.
4. Place your PSPgo into the front of the Stereo Grip.
NOTE: Your PSPgo should be fully closed before inserted into the
Stereo Grip.
5. Slide open your PSPgo.
6. Plug the Stereo Grip’s audio cable into the bottom of your PSPgo.
7. Locate the power switch below the battery compartment on the
back of the Stereo Grip. Slide the power switch to the ON position,
which is indicated by the LED lighting up red.
8. The Stereo Grip’s volume is controlled using your PSPgo’s volume
controls.
HOW TO USE THE M2 MEDIA CARD READER
1. Insert your M2 Media Card (not included) into the back of the M2
Media Card Reader.
2. Remove the top of the M2 Media Card Reader and connect your M2
Media Card Reader to a powered USB port on your computer.
3. Drag and drop your photos, music or data to the M2 Media Card
drive on your computer.
4. Remove the M2 Media Card Reader and slide it into your PSPgo.
NOTE: When not in use, make sure you replace the protective cap on
your M2 Media Card Reader.
USER’S GUIDE
