ASSEMBLING THE TOM
(
Figure A
)
1. Take the drum head and place it on the drum shell with the logo on the drum shell facing up.
2. Take the rim and fit it on top of the drum head, so it is evenly seated around all sides.
Line up the holes in the rim with the mounting lugs on the drum shell.
3. Take the washers and insert them on the tension rods. Insert the tension rods
through the holes in the rim. Screw the tension rods into the lugs. Tighten the
tension rods with your hands making sure the rim is even around all sides.
4. Take the drum key and tune the drum head. Always keep the head evenly
seated on the drum shell. Press down in the center of the drum to stretch the
head while tuning. This is to ensure the drum will not go out of tune as easily.
5. Repeat steps 1 through 4 for the bottom of the drum.
ASSEMBLING THE BASS DRUM
(
Figure B
)
6. Take the clear batter drum head and place it on the side
that is opposite the legs.
7. Take the hoop and place it on top of the drum head while making sure
it is evenly seated around all sides.
8. Take the tension rods and place them through the washers and claw hooks.
Line up the tension rods with the lugs and rest the claw hooks on the hoop.
Hand tighten the tension rod.
9. Repeat step 8 for the remaining tension rods.
10. Take the drum key and tune the drum head. Always keep the head evenly
seated on the drum shell. Press down in the center of the drum to stretch the
head while tuning. This is to ensure the drum will not go out of tune as easily.
11. Turn the drum over.
12. Take the batter drum head with the logo and put it on the drum.
13. Repeat steps 7 through 10.
MOUNTING THE TOMS
(
Figure C
)
14. Insert the long tube into the tom mount of the bass drum.
Tighten the screw. Adjust the height of each tom.
15. Tighten the screw on the tom mount of the drum
16. With the joint of the tom arm, adjust the angle of the tom.
17. Tighten the locks and repeat steps 14 through 16 for
the other tom.
FLOOR TOM
(
Figure D
)
18. Place the heads and rims on the floor tom
repeating steps 1 through 5.
19. Insert the long floor tom rods to raise it off the floor.
ASSEMBLY INSTRUCTIONS
For Standard Drum set DK7500 and Junior Drum set DKJ5500
Continued on back.
Figure A
Figure B
Figure C
Figure D
Tension Rod
Washer
Mounting Lug
Drum Head
Drum Shell
Rim
Drum Shell
Tension Rod
Washer
Claw Hook
Leg
Mounting Lug
Drum Head
Hoop
