The following 9 steps are intended to simplify the installation
process and help you move quicker to your next install
Pa n e l s, K e y Pa d s & m o d u l e s
Quick-start
Installation Guide
Powerseries
™
9047
Contact your DSC distributor
www.dsc.com
1-888-888-7838
Powerseries 9047
1
.
Remove Front Plate
To remove the front plate, place a small screwdriver in the bottom left and right-hand corner slots
of the system.
2
.
Route Telephone Wiring
Begin by routing telephone line wiring, AC and any inputs/outputs that may be required, through the
back plate and wire them to the terminal block.
3
.
Mount the Back Plate
Determine placement location and mount the back plate to the wall using drywall plugs (4) and
screws (4).
WWW.DIYALARMFORUM.COM