Wiring Diagram for
Pickup Models:
No band on earth plays metal like Slipknot, so for Mick Thomson, no earthly pickup would ever suffice.
Mick asked for even tighter bottoms and more top-end bite, and Seymour Duncan delivered the EMTY™,
a pulverizing new edition to our Blackouts line. Mick depends on EMTY to execute his completely
psychosocial tone that defines the Slipknot sound; because to play extreme metal, you need extreme tone.
MICK THOMSON / EMTY
TM
SIGNATURE BLACKOUTS
AHB-3 MickT Blackouts
2 Volumes, 2 Tones
LONG SHAFT POTS ARE AVAILABLE
If you have a guitar that requires long-
shaft potentiometers we will gladly send
you four long-shaft pots (with all of the
nuts & washers) free of charge.:
U.S. CUSTOMERS
email your shipping address to:
wiring@seymourduncan.com
or call (805) 964-9610 ext 501
NON U.S. CUSTOMERS
Visit our website to obtain the contact info
for the Seymour Duncan distributor in your
part of the world: seymourduncan.com.
Seymour Duncan
Seymour Duncan
Using the quick connector system
The basic installation steps include:
1. Remove the strings from your guitar.
2. Remove the pickguard, or mounting ring, and control plate cover from your guitar.
3. De-solder the original pickup’s wires and be sure to remember where they were
connected.
4. Remove the original pickup from the pickguard or mounting ring.
5. Install the Seymour Duncan pickup into the pickguard or mounting ring.
6. If your original pickups were passive, remove the original pots and output jack,
and replace them with the provided 25k pots and stereo output jack.
7. Install the new 25k pots and stereo jack, and connect them as shown, depending
on your control set up. If your guitar is already equipped with 25k pots,
and has active pickups with quick connector cables, then you can simply unplug
the original active pickup from the quick connector, and plug in your new
active Blackout using the quick connector plug that is located on the bottom of
each Blackout.
8. Tin the wires from your Seymour Duncan pickup, and then solder them in place
9. Connect the red wires from all pickups to the red wire from the battery clip.
10. Connect the black wire from the battery clip to the ring terminal of the
output jack.
11. Re-attach the pickguard or mounting ring to the top of the guitar, and replace any
control panel plates.
12. Re-string your guitar and adjust the pickup height so that your pickups balance
with one another. The bridge pickup should be between 1/8” and 1/16” from the
strings when they are pressed down at the highest fret---then adjust the neck (or
neck and middle) pickups to get an even output balance.
5427 hollister avenue, santa barbara, ca 93111
tel 805.964.9610 fax 805.964.9749
www.seymourduncan.com
Wiring Diagram for
AHB-3 MickT Blackouts
MICK THOMSON / EMTY
TM
SIGNATURE BLACKOUTS
