background image

OWNER’S MANUAL

MACHINERY 
DIVISION

MINI-SPRAYFAST

MINI-SPRAYFAST

ADHESIVE APPLICATING SYSTEM

FOR WATER-BASED ADHESIVES

ITEM # 39047

 

Congratulations on your purchase of a Duro Dyne Mini 
Sprayfast Water-based adhesive spray applicator. 
With careful attention to setup and maintenance it 
should provide you with years of trouble free service. 
Should you encounter any difficulties you should 
contact your local Duro Dyne Distributor or Territory 
Manager or you can call our Technical Services Dept. 
on our toll free number: 1-800-899-3876.

SET- UP AND OPERATION

Your Duro Dyne Mini Sprayfast is shipped completely assembled and ready to use.
Place the pickup tube in the pail of Duro Dyne WIT or WSA Water-based adhesive.

NOTE: DO NOT USE THE MINI SPRAYFAST WITH SOLVENT BASED ADHESIVE. DOING SO WILL RENDER THE 
UNIT INOPERABLE AND UNREPAIRABLE.

Adjust both regulators of your Mini Sprayfast to 70 PSI. The pump will start cycling and then stop when fully 
primed. Pull the trigger on the spray gun to dispense the adhesive. The Mini Sprayfast pump should cycle pe-
riodically to maintain pressure. Excessive cycling indicates too little available air. Check for restrictions in your 
air supply or compressor capacity.

The Spray Gun manufacturer’s operation manual is included for proper adjustment, operation and maintenance 
of the spray gun.

CLEAN UP

At the end of the day or prior to an extended period of non use – Place the pickup tube in a bucket of warm 
water and spray through the unit for a minimum of one minute to glush out the unit. 

®

Reviews: