1.
Take Mounting Brackets (Part B and
Part C), and remove the
wingnut/screw assembly (including
the 2 washers).
2.
Take the Tank Holder, and
determine the location on the
Rollator/Walker where you desire
to install the Tank Holder. The
Tank Holder Mounting Brackets
will need to be installed on a
vertical tube of Rollator/Walker.
Make sure to find a location where
the O2 Tank will not tip over.
3.
Based on the desired location,
determine where the Mounting
Brackets should be installed on the
Rollator/Walker.
4.
Based on where the Mounting
Brackets should be installed on
the Rollator/Walker, identify which
two hole positions on the Tank
Holder should
be used to
attach the
two Mounting
Brackets to
Tank Holder.
5.
Attach Mounting Brackets to Tank
Holder by tightening the short
screws into desired hole positions.
Make sure
to align
the Mounting
Brackets
so they will
position
the Tank Holder
vertically along
vertical tube of
Rollator/Walker.
6.
Clamp the Mounting Brackets onto the
vertical tube of the Rollator/Walker.
Thread the long wingnut screw through
one washer, then insert the long screw
through both holes of a Mounting Bracket.
Place the other washer onto the screw
before tightening the wingnut. Repeat for
the second Mounting Bracket.
7.
Insert O2 Tank into Tank Holder, and
tighten Screw Knob (Part D) to secure O2
Tank.
