INSTRUCTION SHEET FOR LOCK NUT CYLINDERS
Repair Parts Sheets for hydraulic hand pumps are available from your nearest authorized
EAGLE PRO Service Center or EAGLE PRO Sales office.
NOTE
PLEASE READ AND FOLLOW THIS INSTRUCTION BEFORE YOU USE EAGLE PRO LOCK NUT
CYLINDERS.
Carefully inspect all components for shipping damage, if shipping damage is found. Please
notify carrier at once. The carrier is responsible for any damage resulting from shipment.
To avoid personal injury or property damage, please follow all safety
precautions. EAGLE PRO cannot be responsible for injury or damage resulting
from unsafe and incorrect products use or system operation, or lack of
maintenance.
DANGER
WARNING
IMPORTANT
is only used when your action or lack of action may cause serious injury or even death.
indicates a potential danger that requires correct action to avoid personal injury.
indicates correct action to prevent damage or equipment failure.
DANGER
Form No. E01104
Rev. A Date: 06.10.2009
EAGLE PRO INDUSTRIES, INC.
Form No. E01104
Rev. A Date: 06.10.2009
The hydraulic equipment operator must be a qualified operator must have correct
training and work experience with hydraulic equipment. Lack of knowledge in any of
these areas can lead to equipment damage or personal injury.
Carefully inspect cylinder, coupler, hose and hand pump before using hydraulic
equipment, if you find any damage, please contact with your nearest Authorized
EAGLE PRO Service Center or Sales office. Any damage can cause personal injury when
you use the cylinder.
To avoid personal injury, please do not modify
hydraulic equipment without
approval of EAGLE PRO.
Please never lift a more than the rated capacity of the cylinder, overloading causes
equipment failure and serious personal injury.
The cylinder is a load lifting device, not a load holding device. After the load has been
raised or lowered, it must always be held mechanically, never work under a load
supported by a hydraulic unit.
Keep hands and feet away from cylinder and workplace during operation to avoid
personal injury.
NEVER put unbalanced or off-center loads on cylinders. The incorrect load can result in
equipment failure and serious personal injury.
or weld
01
SAFETY
1
