1001-B PRECISION GARDEN SEEDER
®
ASSEMBLY and OPERATING INSTRUCTIONS
EarthWay
R
EarthWay
R
PRECISION GARDEN SEEDER ~ Assembly
Model 1001-B (Refer to Figure 1, Page 3 for illustration)
REAR WHEEL
Lower kick stand at front to hold planter upright.
Remove nut, bolt, and axle (22, 18, & 25) from frame.
Insert axle through rear wheel (17), place between frame, and line up with holes in end of frame.
Reinstall bolt and nut (18 & 22), and tighten.
Congratulations on the purchase of this new 1001-B Earthway Precision Garden Seeder. Please contact us if you have any
difficulty with assembly or operation of this product. We can be reached via the telephone at 800-294-0671 or 574-848-7491
Monday - Friday 8:30am ~ 4:00pm or visit us online at www.earthway.com The 1001-B comes with
lifetime
technical
support
,
email us at techsupport@earthway.com.
HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY
5
This seeder comes partially assembled, requiring you to install the wheels, handle assembly and row marker.
5
Assembly time is approximately 15 minutes with basic hand tools.
5
Clean and dry your seeder thoroughly after each use
.
HANDLE
Remove nuts and bolts from Plastic Bag. (These are special lock nuts. A wrench will be required to
remove and install them).
Bolt handle (8) in place using bolt & nut (13 & 14) as shown in Figure 1, Page 3 for illustration.
Install the Row Marker Retainer Clip (10) from the front to the back and press into place in the
holes on the handle.
ROW MARKER
Place row marker shaft (1) in front of row marker bracket and line up holes.
Insert clevis pin (7) through row marker shaft (1) and row marker bracket, and
insert hair pin clip (6) through clevis pin. When not in use, secure the row marker
shaft to the New Row Marker Retainer Clip (10) to hold in place.
A cord may be tied to the handle bracket (24) and row marker shaft (1) for
lowering and raising the row marker.
EarthWay
R
PRECISION GARDEN SEED
ER
®
MODEL 1001-B
1-2014 Pt. #52101
