ASSEMBLY and OPERATING INSTRUCTIONS
for
EarthWay
E
V
-N-S
PRED
®
MODEL 2150
Broadcast Spreader rev 10-06
1.
Remove and identify loose
parts from carton.
2.
Position hopper upside down and install frame using
(4) #14 x 1-1/2” flat head Phillips screws.
PAGE 1
Pt. #52157
R
OCK
S
ALT
IS
NOT
RECOMMENDED
FOR
USE
IN
THIS
SPREADER
. R
EMOVE
AGITATOR
WHEN
USING
I
CE
M
ELT
.
#14 X 1-1/2”
P
LEASE
C
ALL
IF
YOU
ARE
MISSING
ANY
PARTS
,
HAVE
ANY
DIFFICULTY
IN
ASSEMBLY
,
OR
HAVE
ANY
QUESTIONS
REGARDING
THE
SAFE
OPERATION
OF
THIS
SPREADER
. T
HIS
MODEL
INCLUDES
LIFETIME
TECHNICAL
SUPPORT
S
UPPORT
H
OT
L
INE
: 574-848-7491 or 800-294-0671
E
: support@earthway.com
HELPFUL HINTS:
If your spreader does not spread evenly, be sure the
FRONT
on the gear box points to the front of the spreader. The impeller must turn
clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some fertilizer
may become stuck on the impeller blades and will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change the
spread patterns. Wet fertilizer will also change the spread pattern and flow rate.
Clean and dry
your spreader thoroughly after each use.
Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using
Rock Salt
remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily.
Rock Salt
will re-
constitute back into a solid block over night with humidity and will damage your spreader.
