1
MotoWinch
Operating instructions
Content
About this manual
1
1. Brief Description
1
2. Technical Specifications
1
3. Safety
1
4. Components and application
1
5. First use as MotoWinch
2
6. Maintenance
4
About this manual
When text follows a marker (as shown on the left), this means that an important warning indicates that
there is a danger of injury to the user or damage to the device or the motorbike.
Note; the user is responsible for adequate and personal protection while using the MotoWinch at all
times.
1. Brief Description and disclaimer;
The MotoWinch shall only be used as described in these operating instructions. The MotoWinch is not suitable for general
lifting purposes or for applications other than those described in the operating instructions. Using the MotoWinch implies the
supplier's indemnification for damage caused by incorrect or improper use.
NOTE; the MotoWinch is a great tool but it is not a substitute for common sense and
safe riding!
2. Technical Specifications
Article nr.
1707001
Length
112cm
Gross weight
1885 gram
3.
Safety
Avoid to come into contact with moving parts during use. Serious injury may occur. Make sure that the
strap is always rolled evenly. An unevenly rolled strap can cause blocking or damage of strap and
ratchet. Always use the rubber anti-slip foot on hard surfaces. If the surface is slippery, e.g. due to oil
leakage, moss or algae growth, there is a substantial risk that the rubber foot does not provide
sufficient stability. It is up to the user to make a safe assessment of the situation. However, during the
winching, the user must always take position such that, in case of sudden sideway slippage or failure of
the winch, the motorbike cannot fall against or on the user.
4. Components and application
Explanation of the parts;
The Ratchet;
The ratchet is a standard 3 ton or 5 ton (optional) cargo ratchet. The ratchet lever is of such size that the power required for
the various applications is limited. The ratchet must be clean when used and inspected for possible damage. The ratchet has
been pre-mounted to the MotoWinch tube with a pipe locking pin.
The strap;
The strap is a standard 2 ton 200cm strap for use with the MotoWinch. The strap must be at all times undamaged for use in
the MotoWinch. After use, the strap should be cleaned from sand, dirt and grease. If the strap is badly frayed, torn or when the
stitching is broken, it should be replaced. In case of doubt please contact Eastbound.
Using a damaged strap is entirely at
users own risk.
