415U-2-C wireless mesh networking I/O and
gateway installation guide
Antenna installation
When selecting an antenna, consider radio proximity.
Use Figure 1 as a guide for installing an antenna and attaching it
to the 415U-2-C.
Figure 1. Antenna installation
Earth Stake
For maximum
range, install
above local
obstructions.
Earth Conductor
at least 5 AWG
(16 mm2)
*
Wavelength:
340MHz = 35” (88cm)
400MHz = 30” (75cm)
480MHz = 25” (63cm)
Weatherproof
Connections
(recommended:
3M™ 23 self-
bonding tape)
Mast
Coaxial Cable
GND
at least 11 AWG (4 mm2)
Stress
Relief
Loop
Antenna
*
GND
Surge Arrestor
(recommended)
415U-2
Provide good ground
connection to mast,
module, and surge
arrestor.
If ground conditions
are poor, use more
than one stake.
1 Wavelength
(minimum)
Connect Coax to
building earth in
accordance with
6.2 g) and 6.2 i) of
IEC60728-11:2005
Connecting to the module for configuration
•
Download and install configuration application “CConfig”
from EATON website www.eaton.com/wireless
•
Connect to PC using supplied USB cable
•
Connect to the device at 192.168.111.1
Or 1.1.1.1 (firmware v2.4)
•
The PC will be automatically assigned an IP address via DHCP
Username:
user
Password:
user
Instruction Leaflet
IL032054EN
Effective November 2017