Eaton CKT16, Installation Instructions Manual

INS #

Installation Instructions

Model # CKT16
Model # CKT32
Model # CKT48

Serial Enclosure (CKT)

Boîtier série (CKT)

Alojamiento Serial (CKT)

General Information 

The Serial Enclosure is packaged separately from the 

ControlKeeper TouchScreen Logic Board to protect 

components during shipping. This installation instruction 

pertains to the installation of the enclosure for this unit. 

Please refer to the ControlKeeper T installation instruction 

included in the box with the ControlKeeper Logic Board 

for information specific to the logic board installation.
The ControlKeeper T enclosure is available in three 

different sizes: 16 size, 32 size and 48 size. It can be 

configured with different relay types as needed to achieve 

your lighting needs.

Getting Started

1.  Do not discard these installation instructions. Please 

keep for future reference and operation information.

2.  The relays and center rail are protected by shrink-

wrap. Leave shrink-wrap in place until all drilling and 

metal work is complete to protect against metal 

shards getting into component circuitry. 

3.  Always disconnect all power before wiring.
4.  Use only as intended and at the listed voltage.
5.  All installation service must be performed by qualified 

personnel or service technicians.

6.  Install in accordance with National Electrical Code 

and any other codes that may apply.

7.  High voltage is present inside the lighting enclosure. 

Use extreme caution when performing maintenance 

on this equipment. Failure to follow this warning and 

proper safety procedures could result in severe injury 

or death and/or damage to the equipment.

8.  Document all wiring that is terminated to the relays 

so that the lighting control equipment can be properly 

configured and programmed for operation.

Mounting the Enclosure

1.  If the enclosure is a 32 or 48 size, remove the upper 

backplate from the enclosure by using the 1/4 turn 

screws provided. The proper operation of these 

screws is to push in gently and turn 1/4 turn left until 

the screw head is horizontal to release the catch 

mechanism. Turning these screws more than 1/4 turn 

may cause them to break.

2.  Choose a dry location convenient to the circuit 

breaker panel.

3.  Mount the panel on a firm surface using pre-drilled 

holes.

4.  Connect the enclosure to the circuit breaker panel 

using conduit. The conduit punch hole can not exceed 

3 inches from the back of the enclosure. If this 

measurement is exceeded, the logic board will not fit 

properly inside the enclosure.

5.  Remove all cuttings and dirt before removing shrink-

wrap from the relays and center rails.

Note:

N

Make certain that high voltage and low voltage 

wiring enters the enclosure separately. High 

voltage wiring should not be brought into the 

enclosure through the bottom or bottom left corner 

of the enclosure. 

Low voltage wiring can be brought into the enclosure 

from the bottom or bottom left of the enclosure. If low 

voltage wire must be brought into the cabinet from the 

top section, there is a knockout reserved on the left side 

which will allow conduit to be run from the top of the 

enclosure into the low voltage wiring area. Failure to 

separate high voltage from low voltage wiring may cause 

interference with logic board function.