background image

Echoflex Installation Guide

ElahoAccess Interface

Corporate Headquarters

n

Middleton, WI, USA

|

+1 608 831 4116

Web

echoflexsolutions.com

|

Email

info@echoflexsolutions.com

|

Support

service@echoflexsolutions.com

©2022 Echoflex Solutions, Inc. Trademark and patent info: 

echoflexsolutions.com/ip

Product information and specifications subject to change.
Echoflex intends this document to be provided in its entirety.

8186M2143

Rev C Released 2022-04

Overview

The ElahoAccess Interface is a wall
mounted device that works in
conjunction with the ElahoAccess
App. The Interface uses Bluetooth

®

Smart (aka Bluetooth Low Energy or
BLE) wireless technology to provide
access to the Elaho control system.
Use the Interface and the app
together to wirelessly configure
and control your Elaho Presets,
Spaces, Zones, and devices.

Specification

Installation Environment

For indoor, commercial controls use only. Echoflex recommends paying
special attention to the installation environment:

Indoor installation only 0°C–40°C (32°F–104°F), 5%–95%
non-condensing humidity.

A wireless operating distance of no more than 9.1 m (30 ft) between
the ElahoAccess Interface and the mobile device running the
ElahoAccess App.

Obstacles reduce the wireless transmission distance. When possible,
avoid transmitting through walls, ceilings, etc.

Electrical

24 VDC is required to power the interface. Run two each 1.5 mm

2

(16 AWG) wires (typically a black and red wire pair) from the auxiliary
power source for connection to the provided Aux Power pigtail.

Note:

Installation must follow all national and local codes for

electrical equipment. NEC Class 2 product to be wired in
accordance to NEC Article 725 and local jurisdiction requirements.

Summary of Contents for ElahoAccess









Reviews: