P/N 3101917-EN • REV 02 • ISS 11DEC14
1 / 3
FW-22LCDWTS FireWorks
LCD Touch Screen Monitor
Installation Sheet
Description
The FW-22LCDWTS is a 22-inch wide-screen LCD monitor with base,
capacitive USB touch screen, and built-in speakers.
Package contents
The following items are included with the FW-22LCDWTS:
•
One AC adapter (Model DSA-60W-12 1)
•
One standard North American power cord
(NEMA 5-15P to IEC 320 C13)
Other power cord types purchased locally
•
One VGA video cable
•
One DVI-I video cable
•
One touch screen USB cable
•
One 3.5 mm male-to-male audio cable
•
One product documentation CD
•
One drivers CD
Installation
Install this device in accordance with applicable national and local
codes, ordinances, and regulations.
Note:
Installation may require a UL 1481 Listed uninterruptible power
supply (UPS).
To install the monitor:
1. Connect the monitor to the workstation/server. See Figure 1
through Figure 5.
Connect the DVI-I cable (preferred) or the SVGA cable, but not
both. Tighten the connector screws.
2. Plug the AC adapter into the DC-IN connection on the monitor.
Plug the AC adapter power cord into the power outlet.
3. Turn on the monitor, and then turn on the workstation/server.
Windows automatically chooses the best screen resolution, refresh
rate, and other display settings for the monitor. If you need to adjust
the picture quality settings, refer to the product documentation shipped
with the monitor.
For additional setup options, refer to the workstation/server
documentation. For touch screen calibration instructions, see “Setting
up monitor touch screens” on page 2.
Figure 1: Monitor cable connections
(1) SVGA cable connection. See Figure 2.
(2) DVI-I cable connection. See Figure 3.
(3) Audio cable connection (optional). See Figure 4.
(4) AC adapter cable connection.
(5) Touch screen USB cable connection. See Figure 5
