05/19/2016
BI515
ELECTRO-BOILER
TS Series
3-PHASE MODELS, 208-VOLT
INSTALLATION & OPERATING INSTRUCTIONS
Model
EB-WX-13-2
EB-WX-27-2
APPLICATION:
This Electro-Boiler is factory equipped with
WarmFlo
smart controller.
WarmFlo
automatically regulates outlet water temperature based upon outside
temperature and pre-setup parameters (commonly called “outdoor reset”).
Primary application is any hydronic water heating system where reduced flow or
radiation can cause overheat conditions (example, zones).
However
, if it is a
mixture of large and small zones, the sudden capacity and flow changes may
cause some internal timing/over temp conditions. With the mixture of zones the
zone controller ZTS-* option is highly
recommended
(see page 2).
This series is equipped for load management interrupt and can apply to standard
baseboard radiation, dual heat combinations, under floor radiant, wood boiler
supplement, etc.
Note:
If this installation does not include dual heat standby boiler, the front panel
switch must always be in the “normal” position.
ACCESSORIES:
Attached BL001 lists various accessory or option items which are not part of
basic Electro-Boiler. See Room Thermostat Placement for information on slab
stat. See Zone Controller section for information on a zone control update which
stages elements based upon zone capacity.
Note:
This product meets the requirements of the ASME Boiler and Pressure Vessel Code.
