Emergi-Lite
Tel: (888) 552-6467
Fax: (800) 316-4515
www.emergi-lite.com
07/09 750.1357 Rev. D
1/2
Prestige Economizer Series - Edge-Lit Led Exits
Prestige Economizer Series - Edge-Lit Led Exits
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always
be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. Do not use outdoors.
2. Do not let power supply cords touch hot surfaces.
3. Do not mount near gas or electric heaters.
4. Use caution when handling batteries. Avoid possible shorting.
5. Equipment should be mounted in locations and at heights where it will
not readily be subjected to tampering by unauthorized personnel.
6. The use of accessory equipment not recommended by the manufac-
turer may cause an unsafe condition.
7. Do not use this equipment for other than intended use.
8. All servicing should be performed by qualified service personnel.
SAVE THESE
INSTRUCTIONS
Installation Instructions
1. Turn off AC power.
2. Route AC unswitched circuit of rated voltage into junction box and
leave 6” of wire length.
3. Follow directions on the panel for chevron placement. (Note: for sin-
gle sided units with clear background place chevron on back of the
panel).
4. Unsnap cover (12) by using your fingers, lift the bottom of the cover
and remove (if the cover is to difficult to open gently pry the cover
using a flat head screw-driver at the point indicated in fig.1).
Wall Mount (See Figure 1)
a. Extend the AC supply leads with the extension wires supplied (fol-
low the electrical wiring in figure 4).
b. Feed the supplied wires through the center hole of the spider plate
then attach it to the junction box.
c. Feed the supplied wires through the center hole of the canopy
then attach it to the spider plate using the screws provided (6).
d. Remove the knock out towards the inside with a screwdriver. Feed
the supplied wires through the center hole and mount the housing
to the canopy with the screws provided (4).
Ceiling or End mount (See Figure 2 & 3)
a. For ceiling mount: remove plugs (see figure 2)
a. For end-mount: remove the knock outs on the end cap towards
the inside with a screwdriver (see figure 3).
b. Fasten the canopy to the housing using screws(4) and lock nuts
provided (9).
Figure 1
1
2
3
5
6
7
8
10
11
12
4
Pry here
Part List
1.
Junction box (existing)
2.
Spider Plate
3.
Junction box screws (not
supplied)
4.
Canopy screws - long(2)
5.
Canopy
6.
Canopy screws - short(2)
7.
Housing
8.
End cap screws
9.
Lock Nuts
10. Panel holder plugs
11. Panel
12. Cover
