EN
DUST COLLECTOR (DRAWER) FOR MANICURE EMIL Х2P
COSMETIC DEVICE NOT INTENDED FOR HOUSEHOLD USE, TRADEMARK "EMIL"
Instruction Manual
Caution!
- The dust collector (drawer) is not intended for household use! Use it only to perform
the intended functions, i.e. professional use (manicure)!
- This device is not intended to be used by persons (including children) with limited
physical, perceptive or mental abilities nor the persons with lack of experience and
knowledge, except for cases, when they have been trained by the person responsible
for their safety.
- Children should be supervised to prevent playing with the device.
- In case of damaging the power cord, to prevent any hazards it should be replaced by
the manufacturer, relevant service or equally qualified personnel.
- No part of the appliance must interact with water!
Maintenance: When the device has been disconnected for the power supply, wipe the
surfaces of the appliance with a slightly dampened cloth, treated with an
alcohol-based antiseptic solution.Prevent soapsuds from infiltrating the device!
- The dust collector bag should be cleaned by washing it at the end of the working day
in warm water! Manufacturer shall be held liable for the suction capacity of the device
only in case the dust collector bag is completely free of dust!
- Use only original bags included in the kit of the device!
Prevent effects of the direct sunlight on the device!
- Store and use the device in room temperature (from +15°C to +35°C).humidity not
exceeding 60%.
- The failure to comply with this user manual may reduce the safety and quality of this
device.
Dust collector device is intended for collection of dust and small particles produced during
manicure and operations concerning nail growing.
Type
: Desktop
Description
Dust collector (drawer) consists of a body with integrated suction fan with blades protected
with chrome plated metal grid, switch (on the right side, cable and double layered bags
(filters) for collection of dust and small particles.
Preparation for operation and start of the device
Before turning on the device, the dust and small particle collector bag must be attached to
the dust collector (drawer). To perform this operation drawer should be turned so that the
back side would be accessible to manipulations. The filter must be placed on a special ring.
The "pocket" of the bag should be placed on the upper part of the dust collector (drawer).
The rubber elements of the filter should be sealed on the right and left side using the dust
collector (drawer) ring. After installation of the bag it should be unrolled, thus increasing
its internal volume and improving general operation of the device. Insert the power cord
into the outlet, located on the body of the device. The device is switched on using a switch
on the right side.
CAUTION! Warranty is valid only if the client follows the warranty and operation
conditions. Conditions of warranty repairs.
Warranty applies in following cases:
