background image

©2015 EMS Security Group Ltd. All rights reserved                                                Page 2 of 2                                                                       TSD050  Iss 12 09/02/2016   AJM

1 Pre Installation

2 Components

Part No           Product Description

!

4x Lid Fixing Screws

Front Lid

3

Back Box

5 Input Wiring

FC-610-001

Wireless Dual Input/Output Unit

Wireless Input Output Unit

Installation Guide

DUAL I/O UNIT

FC-610-001

FC-610-001

DUAL I/O UNIT

IDENT REV DATE

FC-610-001 EN300 200-2

0359

!

20K

4K7

C

N/O

20K  = Red/Bl

4k7 = Yellow 

EOL Resistor

Configuration

ANTENNA

2

1

3 Remove Cable Entry Points

4 Fix 

to the Wall

 

Use all four circled 

fixing positions to 

ensure a firm fixing.

Use suitable fasteners 

and fixings.

INPUT 1 INPUT 2 

IP-         IP+

IP-         IP+

20k

4k7

C

N/O

Drill the cable entry 

points as necessary.

Cable glands should 

be used.

DO NOT leave 

excess cable in the 

device.

ON

INPUT 1

INPUT 2 

EXPAN1

EXPAN2

OUTPUT 

2

OUTPUT 

1

IP-    IP+ IP-    IP+

3VDC SET

RST

N/O COM

N/C

3VDC

SET RST

N/O COM

N/C

Do Not Use

=

Available 

Cable Entry 

Points

=

Installation must conform to applicable local installation 

codes and should only be installed by a fully trained 

competent person. 

Ensure that the device is installed as per the site survey.

The use of a non-metallic spacer should be considered if 

mounting the device on to a metal surface.

Do NOT Press the Log On button on a pre-programmed 

device, as this will cause communication with the Control 

Panel to be lost. Should this happen, delete the device from 

the system and add it back on.

ATTENTION

OBSERVE PRECAUTIONS

FOR HANDLING

ELECTROSTATIC

SENSITIVE

1

2

3

               ANTENNA

KEEP CABLES AWAY FROM THIS AREA

LOGON

OUTPUT 

2

OUTPUT  1

3VDC SET RST

INPUT 1 INPUT 2 

LED

ENABLE

POWER

INPUT 

INPUT 

FAULT

CLOSED

0

1

1

64

F-SAFE

N/O COM N/C

IP-    IP+ IP-    IP+

3VDC SET RST

N/O COM N/C

EXPAN1

EXPAN2

RELA

Y ON

RELA

Y ON

2

4

8

16

32

ON

1      2       3      4       5      6       7     8

012ABC    

Fixing position 

location within 

cavity

6 Output Wiring

Two resistor monitored inputs are 

available.

Both inputs monitor; closed (alarm), 

open and short circuit conditions.

Each input is factory fitted with an 

end of line 20kΩ resistor.

To connect inputs to external 

devices, wire as shown below. I.e. 

Input 1, using the resistor pack 

provided.

If an input is not being used, leave

the 20kΩ resistor as factory fitted.

EOL

Resistor 

Setup

Remote Monitored Device

Note: Max 

Cable Length 

of 10m

OUTPUT 2

OUTPUT 1

N/O COM N/C N/O COM N/C

Two outputs are also available.

Both outputs are voltage

free and rated 2A @ 24Vdc.

WARNING. DO NOT CONNECT TO MAINS. 

!

All manuals and user guides at all-guides.com

all-guides.com

Reviews: