encor
etworks
TM
e n
!
•
For information on trademarks, safety, limitations of
liability, and similar topics, see
http://www.encorenetworks.com/disclaimer.htm
Using a Three-Pronged DC Power Connector
with a BANDIT II C2C
his document describes assembly and use of a three-pronged DC power connector for
Encore Networks, Inc.’s family of BANDIT™ chassis. The steps also include connection to
AC power, for review.
The three-pronged DC connector is used in the following BANDIT chassis.
• BANDIT II chassis (DC model)
• BANDIT II C2C chassis (DC model)
Caution:
If you have a BANDIT chassis that can use both DC and AC power, it is important
to follow these steps to connect all power sources to that chassis.
If you ordered a BANDIT chassis that uses a three-pronged connector for DC input power, the
package includes a three-pronged DC power connection set (
, and
Figure 3-1. Top Section of Three-Pronged Connector Shell
T
!
Home Module:
Version A, January 2012
© 2012 Encore Networks, Inc.
All rights reserved.
Module TOC
