YG-3504-Drayton-Bollard 20160204
Endon Lighting, LS9 0SE
Drayton Bollard (IP44 Rated)
Safety Warnings
INSTRUCTION MANUAL
• It is recommended that this light be installed by a qualified electrician in accordance with current IEE Wiring
Regulations and Building Regulations (Part P).
• This product is only suitable for connection to a 240v~50Hz supply and is for outdoor use.
• Run supply wire from a 5-amp electrical supply using double insulated 2 or 3-core cable of type H05RN-F
1.0mm2 (not supplied) to selected site, ensuring it is adequately protected through the full length of the
cable run, it must come out of the flat surface of the wall in line with the entry to the fitting
• This fitting is a Class I product, and
must
be connected to Earth.
• Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit breaker
before commencing installation.
• Except where installed in a conduit or duct which provides equivalent protection against mechanical damage,
a cable buried in the ground shall incorporate an earthed armour or metal sheath or both, suitable for use as
a protective conductor, or be of insulated concentric construction. Buried cables shall be marked by cable
covers or a suitable marking tape. Buried conduits and ducts shall be suitably identified. Buried cables,
conduits and ducts shall be at a sufficient depth to avoid being damaged by any reasonably foreseeable
disturbance of the ground.
• Do not install a bulb with a greater wattage or different shape than specified on the label.
• If any modification is made it will invalidate the warranty and may render the product unsafe.
• If the glass or diffuser is broken or cracked it must be replaced, please consult your retailer. This is the
symbol which denotes this requirement:
Assembly/ User Instructions
Before you start
Please read these instructions carefully before fitting and retain for reference. Check the packaging and make
sure that you have all the required parts. Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
1. Decide on the position of the light fitting, or remove existing light fitting. Take a note of the position of the
electrical connections. Ensure there is a solid mounting surface.
2. Run cable (not supplied) from mains electrical supply to selected site, ensuring it is adequately protected
through the full length of the cable run.
3. If installing on existing concrete base, use holes in base as a template to drill suitable fixing holes. Prepare
with suitable ground fixing bolts (not supplied).
4. Thread the cable through the unit, screwing the base into section 3, then into section 4.
