background image

 
 
 
 
 
 
 
 

  P.O. Box 206       Monroe, VA   24574       

www.englanderstoves.com

       Phone:  (800) 516-3636       Fax:  (434) 929-4810 

 

Pellet Stoves 
      Wood Stoves 
          Gas Stoves 
              Multi-Fuel Stoves

Installing the PU-DTSTAT 

 

BEFORE BEGINNING THERMOSTAT INSTALLATION BE CERTAIN 

THE STOVE IS UNPLUGGED AND COMPLETELY COOL.  DEPENDING 

ON WHICH STOVE THE THERMOSTAT IS BEING INSTALLED ON, 

THE CONTROL BOARD MAY NEED TO BE REMOVED FOR 

INSTALLATION. 

 
1. Using a small, slotted screwdriver (often referred to as a jeweler’s screwdriver), 
loosen the two screws on the front of the J18 thermostat terminal, shown below 
and remove the jumper which is installed in the terminal from the factory.  This 
jumper should be set aside and saved. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
2. Insert one of the thermostat wires into each of the terminals on the bottom of the 
J18 thermostat connection block and tighten the screws on the front of the 
thermostat terminal.  The thermostat wires should be securely held in place by 
these screws (remember that the thermostat is not polarity specific, so it will not 
matter which wire goes into either terminal). 

Connect 

thermostat 

wires here 

(J18) 

Reviews: