NIGHT VISION® LCD ALARM
Model 30330B
Thank you for your purchase of this amazing clock. The utmost care has gone into the design and manufacture of your clock. Please
read these instructions and store them a safe place for future reference.
Night Vision ® Technology
This clock incorporates Night Vision ® Technology. This cordless battery operated feature allows you to see the time in a dark room.
When light level is extremely low the light SENSOR (7) automatically illuminates a dim glow behind the digital display. When your
eyes adjust in a darkened room, you can still see the time! The sensor automatically turns off the Night Vision ® glow when the room
brightens.
You can also activate a bright backlight display anytime by pressing the SNOOZE/LIGHT bar (3).
TO INSTALL AND REPLACE BATTERIES
The LCD clock uses three 1.5V "AA" batteries. (Not included)
To install and replace the batteries. Please follow the steps below.
1.
Remove the battery cover.
2.
Insert batteries observing the correct polarity (see marking inside battery compartment).
3.
Replace the battery cover.
Note: Do not mix new and old batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel cadmium)
batteries.
TO SET THE TIME
1. Hold the TIME SET button (5) and press the HOUR button (1) to your desired hour. Be careful to set the time to AM or PM
correctly. When PM time is set. The letter "PM" will appear.
2. Hold the TIME SET button (5) again, press the MINUTE button (2) to your desired minute. –
TO SET THE ALARM TIME
1. Hold the ALARM SET button (6) and press the HOUR button (1) to your desired hour. Be careful to set the time to AM or PM
correctly. When PM time is set, the letter "PM" will appear.
2. Hold the ALARM SET button (6) again, press the MINUTE button (2) to your desired minute.
