N
O TE
:
Do not attach the base
station to your PC until instructed
to do so.
If you run into difficulties, see
“Chapter 2: Installation” in your
CG
2400 User Guide
for more information.
1
Unpack the Components
Not shown:
•
Base station wall mount
•
Battery pack for the handset
•
CyberGenie@Work CD-ROM
•
CG 2400 User Guide
•
Handset Quick Reference
2
Install the Handset Battery
a
Remove the cover from the back of the
handset.
b
Plug the battery wire into the white
connector inside the handset at the top
right.
c
Route the wire through the guide.
d
Place the battery securely inside the
battery compartment.
e
Replace the cover.
3
Charge the Handset
N
OTE
:
If using the wall mount, install
mount on wall before connecting the
charger to the mount.
DA 202 Base station
2 standard
phone cords
USB
cable
Base
station
desk
stand
Handset power supply
Handset
charger
DG 200 Handset
with detachable clip
Base station
power supply
10 Easy Steps to Quick Installation
For the CG 2400 PC Cordless Phone System
a
Insert the power supply plug into the
socket on the back of the charger.
b
Attach the mount to the charger.
c
Plug the power supply into an approved
electrical outlet.
d
If the handset is on, press until the
handset turns off.
e
Insert the handset securely into the
charger.
f
While charging, the green indicator light
on the charger will be on. When the
handset is fully charged, the indicator
light will go off.
N
OTE
:
Let your handset charge for at
least three hours before first use.
4
Before Installing Software
a
Close any open software programs.
b
From the Windows
Start
menu, select
Settings> Control Panel.
c
Click
Power Management
.
d
On the Power Schemes tab, select
Always On
.
e
Select
Never
for
System standby
(not
present in all installations).
f
Select
Never
for
Turn off hard disk
.
g
Click
OK
to save.
N
OTE
:
If using Microsoft
®
Outlook
®
,
see “Ensuring Outlook Support” on
page20 of your
CG 2400 User Guide
before
installing CyberGenie@Work.
5
Install the Software
N
OTE
:
Do not attach the base
station to your PC until instructed
to during the installation process!
a
Insert the CyberGenie@Work CD into
your CD-ROM drive.
b
When the installation program loads,
click
Install
.
c
Follow the screen instructions until the
prompt appears:
Connect the base
station to your PC USB port.
At this
point, pause the software installation
procedure and prepare the base station.
6
Prepare the Base Station
a
Remove the warning
sticker on the bottom
of the base station so
the sockets are
visible.
b
Mount base station:
For desktop use
,
attach the base
station to the stand as
shown.
For wall mounting,
see “To mount the
base station:” on
page23 of your
CG
2400 User Guide
.
USB connection
Line 1 socket
Fax/modem socket
Line 2
socket
Power
socket
Wire Guides
