MODEL NO.
B5404F
Silverback
BASKETBALL SYSTEM
2L-7210-01
Escalade
®
Sports products may be manufactured and/or licensed under the following patents:
6419596, 6179733, 5919102, 5071120, 4798381, 4424968, D326128, 7244046
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.
2011 Escalade Sports
1. Read this manual carefully before starting assembly.
Read each step completely before beginning
each step.
2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons
before assembling or ordering parts.
3. To make assembly of your basketball system easier, use the Hardware Identifier on page 3
to identify and sort all fasteners. Check all cartons for kits. All hardware may not be located
in one kit.
4. Do not tighten hardware until instructed to do so.
If hardware is tightened too soon, mounting holes
may not align and parts may not easily fit together. Leave locknuts slightly loose until you are instructed to
tighten them.
O W N E R ' S M A N U A L
5.
B5404W
©
Please Do Not Return This Product To The Store!
Contact Escalade
®
Sports customer service department at:
Phone:
1-888-USA-GOAL
Toll – Free!
Fax:
1-866-873-3536
Toll – Free!
E-mail:
basketball@escaladesports.com
Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706
Please visit our World Wide Web site at:
www.escaladesports.com
ON-LINE TROUBLE SHOOTING
TECHNICAL ASSISTANCE
ON-LINE PARTS REQUESTS
FREQUENTLY ASKED QUESTIONS
ADDITIONAL ESCALADE
®
SPORTS PRODUCT INFORMATION
ITEMS NEEDED (not included)
9-
1-
1-
1-
1-
1-
6-
2-
1-
1-
1-
1-
1-
1-
1-
50 lbs bags of concrete
Post hole digger (optional)
Wheel barrow
Garden hose
Level
Tape Measure
2X4’s
50 lbs sand bags
Standard masonry block
Adjustable Wrench
9/16” Wrench
3/4” Wrench
Pair of Safety Glasses
Phillips Screwdriver
Ladder
Save this instruction in the event that the manufacturer has to be contacted for replacement
parts.
6.
An electric screwdriver is helpful in assembly. However, please
set at low torque and use caution
because you could overtighten the hardware and strip the screws.
