Your Finished enjoy your Bench
Starting the assembly processes
1. Turn over the seat
2. Place the 4 TPR washers to the position as shown in the picture
to below
3. Turn over the leg then put it on the seat
4. Align the hole on the leg with the seat and TPR washer hole
5. Install metal washers on to the leg
6. Use the Hex Key Wrench to fasten the screws
Repeat steps 1-6 on the other side of the bench so you have
both leg assemblies installed.
Curved Bench
Assembly Instruction
After unpacking the Curved Bench from the packing material
locate the following parts to insure you have everything to
assemble the bench your package will contain the following
bench components as shown in Picture to below:
Assembly Hardware
After unpacking the Bench from the packing material locate the
following assembly hardware and set it out as shown in the picture
to below
：
1 EA. Hex Key Wrench
8 EA. TPR Washers
8 EA. Screws
8 EA. Metal Washers
1 EA. Bench Seat
2 EA. Bench Leg
1 EA. Bag of assembly hardware
owner’s
manual
Date of purchase: _____/ _____/ _____
CURVED BENCH
Caution:
Product code: 820-02649837-8
UPC code: 713022906211
Made in / Hecho en CHINA for Kmart Corporation, Hoffman Estates, IL 60179
SHOP kmart.com
See our extensive assortment of outdoor living products
on-line at www.sears.com and www.kmart.com
For questions or comments about product:
Email: help@victorylandgroup.com or Call toll-free: 1-800-933-0527
Please refer to part numbers when reordering
