Please read these instructions before use.
This bath board is designed as a temporary
seating aid only. Do not use the board as a step.
Do not tip or put an offset load onto the board or
injury may occur.
Do not install the bath board if there is a shower
door track on the side of the bath.
Supervision or assistance is recommended
for users with limited mobility when using the
bath board.
Bath Seat / Board
Slatted
Set-up and operation
The Bath Seat /Board, Slatted is
manufactured from reinforced
polypropylene slats with slip
resistant rubber ends and unique
locking swivel brackets enabling the
board to be used with a variety of
bath shapes.
Some minor assembly is required.
Box Contents and Inspection
Carefully remove all components from the box,
remove all packaging and plastic wrapping and check
items against the list below. Any damaged or missing
components should be reported to your authorised
dealer or Evadale Healthcare.
Assembly
To attach the cleats, turn the board upside down and
position the clamping bracket over the bolt hole with
rubber pads facing outwards. Insert bolt and wing
nut, and screw to tighten loosely enough to allow the
bracket to slide freely for final positioning when in
bath. Repeat on opposite side.
slatted bath board
2 x bolts / wing nuts
2 x clamping brackets
Set-Up and Operation Instructions (this guide)
The bath board can be slippery when wet
– use with caution.
The edge of the bath must be wide enough to
support at least 40 mm of each end of the bath
board. When installed ensure that the bath
board does not overhang the outer edges of the
bath.
When using a bath board, it is recommended
that the user be able to sit with good balance;
to lift their legs over the edge of the bath; and to
bend at the hips.
