CHARGING
USER GUIDE
SIX PACK MK9 • MAXX D MK11 • TORO MK10 • RACE MK13
STRADA SB • STRADA RS • STRADA SL
IMPORTANT:
•
After charging is complete, remove the charging cable from the light (if the light is left
connected with the charger off, the light can switch on)
•
Replace the Storm Cap to prevent ingress of mud and grit
•
Do not charge the light with the lens face down or in contact with any potentially
combustible surface
•
Do not charge the light in an enclosed space
Fully Charge your light
before
first use.
Locate the charging port by pulling away the silicone Storm Cap.
Fully insert either the Smart Charger or USB top up cable and begin charging from a mains or USB
supply respectively.
If you are using the Smart Charger the LED on the charger will go red for the first 95% and then go
green for the trickle charge.
On the back of the light the OLED display screen will show the approximate charge level, once the
light says ‘100%’ leave it charging for a further hour. The percentage shown is most accurate when
the light is in operation.
NOTE:
If you are charging your light from when its battery level is very low you may see a code appear
on the OLED screen resembling ‘M00145’. This is a recalibration code and nothing to worry about.
FUNCTION
BUTTON
OLED
SCREEN
STORM CAP
(CHARGE PORT
/SMART PORT)
APPROX MAINS CHARGER TIMES
SIX PACK
8 HRS
MAXX D
6 HRS
TORO
6 HRS
RACE
6 HRS
STRADA SB
6 HRS
STRADA RS
6 HRS
STRADA SL
3 HRS*
*3 hours from 500mA source
with supplied USB cable.