EMX Alpha / Beta / Delta / Gamma / Omega Ranges
WARNING READ INSTRUCTIONS CAREFULLY BEFORE USE
INFLATABLE INSTRUCTIONS
Recommended procedure below. For safety reasons it is recommended that 2 persons set up any marquee.
Ensure area is free from any sharp objects & overhead objects.
SETUP - INFLATION
Remove Inflatable Marquee from
Protective Cover.
Lay the Inflatable Marquee out flat.
Roll out the marquee.
ONE
TWO
THREE
During the inflation process raise legs
into the center until all legs are upright.
Ensure all legs are lined up and roof
is centered. Check frame is firm.
Connect the pump to selected Inflation
Valve and begin inflation.
SEVEN
EIGHT
NINE
Each leg on the marquee has a valve. Select
valve to attach pump, screw inflatation value
closed and leave cap off.
On all other valves screw tight and fix cap.
Marquee Accessories*
Layout your Walls and Awnings and
confirm positioning.
Attach the accessories using zips.
SIX
FOUR
FIVE
Fix Steel Pins and Guide Ropes or
attach Sandbags.
Over pressure relief valve system,
DO NOT TOUCH.
IMPORTANT NOTES:
Check the wind and weather
conditions before commencing
construction.
Ensure you have the correct ground
fixings for your application.
When the marquee is in use, do not
leave your marquee unattended.
TEN
We design
|
We manufacture
|
We sell
|
We Deliver Australia wide
www.extrememarquees.com.au admin@extrememarquees.com.au
1300 850 832
