Falcon 25 Series Installation Instructions Download

Page: 1 / 4

*23963390*

23963390

PREPARE FOR INSTALLATION

Remove and discard existing cover plate.

Cover Plate

If exit device has dogging, remove device from door.

If exit device does not have dogging (Fire or less dogging
applications), skip to step 4.

25-R Device

Shown

Installation Instructions

24/25 Series Exit Alarm Kit

• The Exit Alarm Kit requires a RX or LX switch mounted in the exit device.

9 Volt Battery

Battery Holder

Cylinder

Nut

Battery Clip

Cover Plate

Alarm

Hardware

Mortise cylinder

sold separately

¹⁄₄

(32 mm)

Standard cam

Important Note

Summary of Contents for 25 Series

Page 1: ...ice does not have dogging Fire or less dogging applications skip to step 4 25 R Device Shown EA Installation Instructions 24 25 Series Exit Alarm Kit The Exit Alarm Kit requires a RX or LX switch moun...

Page 2: ...alarm unit with the parts in order as shown below Cam should be in OFF position before battery is installed 6 If exit device does not have LX or RX switch install switch before proceeding a Remove pus...

Page 3: ...ts the exit alarm When the access control contacts are re opened the exit alarm re arms with no delay RX LX and EI inputs are not polarized Gray Black Violet Von Duprin 24 VDC Power Supply Polarity Se...

Page 4: ...kwise to position B until it stops Return key to position A to remove L L Note There is a 15 to 20 second delay before arming during which the LED will flash every 3 to 5 seconds B A RHRShown LHRoppos...