background image

*030388-000-70*

030388-000-70

© Allegion 2014

Printed in U.S.A.

030388-000-70 Rev. 10/14-d

Customer Service

1-877-671-7011

www.allegion.com/us

Mounting and Rehanding

Installation Instructions

RW Series 

Retrofit Lever Trim

STEP ONE: 
Remove all existing trim from door, 
including cylinder if one is installed.

STEP  TWO: 
Insert inner and outer spindles into lock hubs.  

NOTE: Because of various hub sizes, be sure 
spindles fit properly. 

Place the enclosed template 

over the spindle. Align with door edge and mark the 
four (4) thru-bolt hole locations. This should be done 
to both sides of the door. Drill the four (4) holes 
halfway through from each side of door.

IMPORTANT: It may be necessary to enlarge the 
trim hole due to varying door preps. Falcon retrofit 
trim requires both sides to be 1

¹⁄₈

” diameter 

minimum to clear trim mechanism.

STEP THREE: Before mounting the trim, be 

sure to insert spindle springs into each 

lever. With spindle in outer hub, place outer 

trim over spindle with posts going into thru- 

holes. Place inside trim over spindle and 

install the four (4) mounting screws. Before 

screws are tightened, check to see that  

both levers are operating properly. If 

reinstalling the cylinder, determine if a 

blocking ring is required. Tighten set screw 

then check cylinder for proper function. 

Tighten the four (4) trim mounting screws.

REPLACEMENT PARTS

Spindle

Spindle

Adapter

Spring

P/N 021242–001–30

P/N 030329–000–30

P/N 030319–000–30

P/N 021244–001–60

5/16”

9/32”

5/16”

5/16”

3/8”

SPINDLE

TEMPLATE

SCREW

6-32x1

¹⁄₄

INSIDE

SPRING

SPINDLE

SPRING

OUTSIDE

TRIM HOLE

Reviews: