Connector : WSO 1031
with sealed or unsealed cable clamp
Fischer Connectors SA
Saint-Prex, Switzerland
Phone +41 21 800 95 95
Fax +41 21 800 39 24
www.fischerconnectors.com
mail@fischerconnectors.ch
Assembly Instruction
Instruction de Montage
Montageanleitung
Tool Required
For all versions:
•
Flat Spanners:
•
12 mm
• Wire Cutter
• Stripping Tool
• Soldering Iron
Fischer Part Number
TX00.012
Additional tools for Crimp Contact versions:
•
Crimping Tool for:
•
Positioner for:
Fischer Part Number
TX00.240
TX00.301
TX00.303
TX00.304
TX00.305
2 - Strip Cable
1 - Disassemble Connector
3 - Assemble Clamp Set
Document No. 600.00.439
Rev : 1.2
Date : 18-May-2015
Established by : ARZ/VGI
Approved by : SKE
© Fischer Connectors SA / All rights reserved
This document is the property of Fischer Connectors SA.
All communications to third parties or the reproduction in any form, even partial, are prohibited without our written consent.
Connector
Body (a)
Contact
Block (b)
Right Angle Body (c)
Spacer (d)
O-ring (e)
Back Nut (f)
Ring (g)
Cap Nut (j)
Cable Clamp (i)
Seal (h)
A
C
A
A
≈
20-22 mm
(1)
B
≈
2 mm
(1)
C
≈
(6 – 1/2 cable Ø) mm
(1) (2)
Or trim shield after step 3
if possible
B
(2)
(1)
These values are given for reference and must
be adjusted to each specific cable
construction.
It is recommended to strip “B” after step 3.
Sealed Clamp Version
Unsealed Clamp Version
Jacket position for
non-shielded cables
Cable Shield
Ring (g)
Seal (h)
Cable Clamp (i)
Right Angle Body (c)
Recommended torque value: 1.5 Nm
(depending on cable)
Threadlocking adhesive recommended
(*) See note (2) in step 2
12
(*)
(*)
Cap Nut (j)
• 0.5 to 1.3mm contacts
• 0.5mm male contacts
• 0.5mm female contacts
• 0.7mm male contacts
• 0.7mm female contacts
See step 4:
with large
cables, insert
spacer before
Page 1/2
