Part No: 20632-1 03/19 Page 1 of 3
Restart or Factory Reset a WiFi Device
This Help Guide refers to Diligence™ WiFi data loggers, including Sensors and Alert
How do I Restart or Reset my Diligence™ WiFi data logger?
Under normal circumstances, you do not need to reset your Diligence™ WiFi data logger. However
you may be instructed to do this by our support team to recover a Device which is not working
properly, or return it to its factory state.
Restart
Performing a Restart on the WiFi Sensor will restart the internal firmware, retaining all configuration
and network settings. The Sensor will disconnect from the wireless network, and immediately enter
a low power sleep mode. It can take up to 30 minutes for the Sensor to re-connect and synchronize
after a Restart. Under normal circumstances the Sensor will synchronize within 15 minutes. Once
communication is re-established the Sensor returns to its normal transmission rate. A Restart will
cause a new recording session to be started.
To perform a Restart...
What is this?
RF313-TH
From the Sensor Home screen
Press and hold the button for 10 seconds
Release when the
LOW
symbol starts to flash.
All other Sensor types
RF311-T, RF312-TP, RF312DualPlus,
RF312Glycol, RF314-TC, RF314Dual
From the Sensor Home screen
Press and hold the button for 10 seconds
Release when the LCD shows
