background image

1

Carton Contents

IMPORTANT!  Please check the contents of the carton are correct 

BEFORE assembling your new Flymo product.

IF ANY PARTS ARE MISSING CONTACT:

Husqvarna UK Ltd. Customer Service Department direct

Telephone: 0344 844 4558  

UK 

 

1800 882 350  

ROI 

 

FAX: 01325 302530

Safety

General

1. 

This product may be used under supervision, 

or if instruction regarding the safe use of the 

product has been provided and the resulting 

  dangers have been understood, by children 

aged 8 and above, as well as by persons with 

physical, sensory or mental disabilities or a 

lack of experience and knowledge. Children 

must not be allowed to play with the product. 

Cleaning and user maintenance must not be 

  performed by children without supervision. 

The use of this product by young  people 

under the age of 16 is not recommended.

2. Never allow children or people unfamiliar with the 

instructions to use the machine.

3. Stop using the machine while people, especially 

children, or pets are nearby.

4. Only use the trimmer in the manner and for the 

functions described in these instructions.

5. Never operate the trimmer when you are tired, ill or 

under the influence of alcohol, drugs or medicine.

6. The operator or user is responsible for accidents or 

hazards occurring to other people or their property.

Battery 

Cordless Battery Powered Products require special 

care.

1. 

AVOID ACCIDENTAL STARTING.  KEEP HANDS 

AND FINGERS AWAY FROM THE SWITCH LEVER 

WHILE CARRYING THE TRIMMER.

2. 

Always charge the product indoors and store in a 

cool dry place – out of the reach of children.

3. 

Use only the charger provided with your unit.   

Use of any other charger could permanently 

damage the battery and the trimmer.

4. 

Use the charger with standard domestic household 

electrical outlets only.

5. 

Do not abuse the charger or charger cord.

6. 

Do not use the charger if the charger or charger 

cord is damaged.

7. 

Use the charger indoors only.

WARNING.  When using the product the safety rules must be followed.  For your own safety and 

that of bystanders please read these instructions before operating the product.  Please keep the 

instructions safe for later use.

Explanation of Symbols on the product

Warning

Read the user instructions carefully to make 

sure you understand all the controls and 

what they do.

Keep others, including children, pets and 

bystanders outside the 10 metre hazard 

zone.  Stop the trimmer immediately if you 

are approached.

Wear eye protection

To avoid the possibility of electric shock, 

do not use in damp or wet conditions.

 

  Switch off! Remove battery pack before 

adjusting or cleaning.

Warning: The cutting line continues to rotate after the 

machine has been switched off.

360º

10m

2

8. 

Do not use the charger outdoors.

9. 

Store and charge this unit in a cool, dry well 

ventilated location and out of the reach of children.

10. Do not charge the battery or use the unit in an 

explosive or corrosive environment.  Avoid areas 

where flammable liquids or gases are present to 

avoid creating a fire or explosion.

11. Do not attempt to repair the unit including the

 

battery.  Nylon line replacement and cleaning the 

unit are the only items suitable for user maintenance.

12. Do not insert any object into the motor area.  

 

Keep free of debris to avoid overheating.

13. Do not incinerate or mutilate the battery. Batteries 

contain hazardous chemicals.  Dispose of properly.

Preparation

 1

. While using your product always wear eye protection,

  

substantial footwear and long trousers. Do not operate 

the equipment when barefoot or wearing open sandals.

 2

. Before using the machine and after any impact, check

 

for signs of wear or damage and repair as necessary.

 3.

 Inspect the area to be cut before each use. 

Remove all objects such as stones, broken glass, 

nails, wire, string etc, which can be thrown or 

become entangled in the trimmer head.

 4.

 Before use, inspect the area for wildlife, especially 

hedgehogs.

 5.

 Check that the cutting head, spool and cap are 

fitted correctly.

Use

 1

. Use the trimmer only in daylight or good artificial light.

 2.

  Avoid operating your trimmer in wet grass, where feasible.

 3.

 Take care in wet grass, you may lose your footing. 

 4.

 On slopes, be extra careful of your footing and 

wear non-slip footwear.

 5.

 Do not walk backwards when trimming, you could 

trip.  Walk, never run.

 6.

 Never operate the trimmer with damaged guards or 

without guards in place.

 7.

 Never fit metal cutting elements.

 8

. Keep hands and feet away from the cutting means at

 

all times and especially when switching on the motor.

 9.

 Keep cutting head below waist level.

10

. Do not lean over the trimmer guard whilst trimming or

 

edging – objects may be thrown by the cutting line.

11. Beware of cut-off pieces of nylon line ejected during use.

12. If you hit an object, do not use your trimmer until 

you are sure that the entire trimmer is in a safe 

operating condition.

13. If the trimmer starts to vibrate abnormally, check 

immediately.  Excessive vibration can cause injury.

Maintenance and storage

 1.

 Keep all nuts, bolts and screws tight to be sure the 

trimmer is in safe working condition.

 2.

 Replace worn or damaged parts for safety.

 3.

 Only use the replacement cutting line specified for 

this product.

 4.

 Only use replacement parts and accessories 

recommended by Husqvarna UK Ltd.

 5.

 After any maintenance in dealing with the cutting 

line, always return the product to its normal 

operating position before switching on.

 6.

  To avoid the risk of injury keep fingers and hands clear

 

of the line cutter on the leading edge of the guard.

 7.

 Clean unit with a dry cloth.  Never use metal 

objects to clean the unit.

 8.

  Inspect and maintain the trimmer regularly. Any 

 

repairs must be carried out by an authorised repairer.

 9.

  Store the product in a cool, dry place and out of reach

 

of children.  Do not store the product outdoors.  

10. Allow the product to cool for at least 30 minutes 

before storing.

Battery Pack

Battery Pack Care

1. If over a period of time the Battery Pack quickly 

runs down after a full 6 hour charging period, a  

replacement Battery Pack is needed.

2. There will be some charge present in the Battery 

Pack but to ensure maximum running time, charge 

your Battery Pack for 6 hours before first use.

3. To prevent permanent Battery Pack damage, never 

store in a discharged condition.

4. Contact your local approved service centre/dealer/

distributor for a replacement Battery Pack and for 

safe disposal of your old Battery Pack.

5. 

Battery 

24 Volt 1.6 AmpHour       "High Power" 

Sealed for Life                 No maintenance required

• 

IMPORTANT 

DISPOSE OF YOUR OLD BATTERY PACK SAFELY 

DO NOT CUT OPEN, BURN OR INCINERATE.

Winter Storage

1. Fully charge for 6 hours before winter storage.

2. Re-charge the Battery Pack every 3 to 4 months for 

a full 6 hour charging period to top up the battery 

charge during winter storage.

3. Avoid extended storage without re-charge.

4. Store in a cool dry place.

For further information on Battery Pack 

replacement contact Husqvarna UK Ltd. Customer 

Service direct:

Telephone:  0344 844 4558 UK   1800 882 350  ROI 

Fax:  01325 302530

5857337-02

If any part is found to be defective due to faulty manufacture 
within the guarantee period, Husqvarna UK Ltd., through 
its Authorised Service Repairers will effect the repair or 
replacement to the customer free of charge providing:
(a)  The fault is reported directly to the Authorised Repairer.
(b)  Proof of purchase is provided.
(c)   The fault is not caused by misuse, neglect or faulty 

adjustment by the user.

(d)   The failure has not occurred through fair wear and tear.
(e)   The machine has not been serviced or repaired, taken 

apart or tampered with by any person not authorised by 
Husqvarna UK Ltd..

(f)   The machine has not been used for hire.
(g)   The machine is owned by the original purchaser.
(h)  The machine has not been used commercially.

This guarantee is additional to, and in no way diminishes the 
customers statutory rights.

Failures due to the following are not covered, therefore it is important 
that you read the instructions contained in this Operator’s Manual 
and understand how to operate and maintain your machine:

Failures not covered by guarantee
*  Replacing Nylon Line.
*  Failures as a result of not reporting an initial fault.
*  Failures as a result of sudden impact.
*  Failures as a result of not using the product in accordance 

with the instructions and recommendations contained in this 
Operator's Manual.

*  Machines used for hire are not covered by this guarantee.
*  The following items listed are considered as wearing parts 

and their life is dependent on regular maintenance and are, 
therefore not normally subject to a valid warranty claim: 
Nylon Line, Spool and Line.

* Caution! 

Husqvarna UK Ltd. does not accept liability under the 
warranty for defects caused in whole or part, directly or 
indirectly by the fitting of replacement parts or additional 
parts that are not either manufactured or approved by 
Husqvarna UK Ltd., or by the machine having been modified 
in any way.

Guarantee & Guarantee Policy

Service Recommendations

•  Your product is uniquely identified by a silver and black product rating label.
•  We strongly recommend that your product is serviced at least every twelve months, more often in a 

professional application.

EC Declaration of Conformity

Husqvarna AB, S-561 82, Huskvarna, Sweden
Declare under our sole responsibility that the product(s);
Designaion....................................

Lawn Trimmer

Designation of Type(s)..................

CCTE25

Identification of Series...................

See Product Rating Label

Year of Construction......................

See Product Rating Label

Conforms to the essential requirements & provisions of the following EC Directives:

2006/42/EC, 2006/95/EC, 2004/108/EC, 2000/14/EC, 2011/65/EU

based on the following EU harmonized standards applied:

EN 60335-1, EN 60335-2-91, EN 60335-2-29, EN 62233, EN 55014-1, EN 55014-2
The maximum A weighted sound pressure level L

pA

 at the operator’s position, measured according to EN60335-2-91 is given in the 

table.
The maximum hand / arm vibration weighted value a

h

 

measured according to EN 60335-2-91 on a sample of the above product(s) is 

given in the table.
2000/14/EC: The Measured Sound Power L

WA

 & Guaranteed Sound Power L

WA

 values are according to the tabulated figures.

Conformity Assessment Procedure...............  Annex VI

Notified Body.................................................   Intertek, Davy Avenue,  

Knowlhill,  

Milton Keynes,  

Bucks, MK5 8NL,  

England

Ulm, 05.11.2013

P. Lameli

Chief Technical Officer

Keeper of technical documentation

Type
Width of Cut (cm)
Speed of Rotation of Cutting Device (rpm)
Measured Sound Power L

WA

 (dB(A)) 

Guaranteed Sound Power L

WA

 (dB(A))

Sound pressure L

pA

 (dB(A))

Uncertainty

 K

pA

 (dB(A))

Hand / arm  vibration  a

h

 (m/s

2

)

Uncertainty K

ah

 (m/s

2

)

Weight (Kg)

Our policy of continuous improvement means that the specification of products may be altered from time to time without prior notice. 
Copyright © 2015 Flymo S.A. All rights reserved.  Flymo

®

 and other product and feature names are registered or unregistered 

trademarks of Flymo S.A.

Husqvarna AB 

S-561 82 Huskvarna 

Sweden

Assembly Instructions

Assembly of Switch Handle to Tube (A1)

• 

Ensure that the internal cable is not twisted.

1. 

Insert the tube into the switch handle.  

2. 

Push until it clicks into position.

• 

ENSURE THAT THE TUBE IS FULLY LOCATED 

BY ATTEMPTING TO REMOVE IT.

Assembly of Trimmer Head to Tube (A2)

• 

Ensure that the internal cable is not twisted.

1. 

Insert the tube into the trimmer head.  

2. 

Push until it clicks into position.

• 

ENSURE THAT THE TUBE IS FULLY LOCATED 

BY ATTEMPTING TO REMOVE IT.

Wheel Assembly (B1) & (B2)

1. 

Attach the wheel to the trimmer making sure that it 

is located into the BOTTOM groove on the trimmer 

head as illustrated in 

fig B1.

2.  

Clip the wheel together on each side making sure it 

is secure (

B2).

3.  

The wheel should turn freely.

Plant Guard Assembly (B3) & (B4)

1. 

Open the plant guard as illustrated in 

fig. B3 and 

place into the TOP groove on the trimmer head. 

Rotate the plant guard clockwise until it CLICKS into 

its parked position (

B4).

A1

A2

CLICK!

CLICK!

B1

B3

B2

B4

Replacement Parts

Spool and Line
Reference no.: 

FLY047

Part no.: 

510747890

0344 844 4558 

UK   

1800 882 350 

ROI

®

Original Instructions

IMPORTANT INFORMATION

Read before use 

 

& retain for future reference

Contour Cordless 

24 V

Upper Shaft

Guard

Instruction 

Manual

Lower Shaft

Steady Handle

Wheel

Plant Guard

Safety Lock-off Switch

Battery Pack

Battery Charger

CCTE25

25

8,500

82
96

74.4

2.5
1.8
1.5
3.2

1

0/2015

5857337-02 Contour Cordless 24V UK.indd   1

16.10.15   08:56

Reviews: