background image

Sirius F80/F80P Manual

 

 

 

The Sirius F80 and F80P are card readers that are specifically designed to be used with Fore! 
security management software. The Sirius F80 and F80P card readers can read MIFARE 
Classic and DESFire EV1 access cards that use a Fore! encoding and the UID (or CSN) of 
Mifare and DESFire cards without a Fore! encoding. The Sirius F80P is equipped with a 
pinpad.  

Inhoud 

 

1 Location 

 

2 Mounting 

 

3 Wiring 

 

4 Pinpad operation 

 

5 Technical data 

Location 

Choose a location for the card reader that meets the following constraints:  

 

The distance between the card reader and the Polyx NF+ door controller is less then 120 
meter.  

 

There is at least 20cm space between two card readers.  

 

Summary of Contents for Sirius F80

Page 1: ...t use a Fore encoding and the UID or CSN of Mifare and DESFire cards without a Fore encoding The Sirius F80P is equipped with a pinpad Inhoud 1 Location 2 Mounting 3 Wiring 4 Pinpad operation 5 Technical data Location Choose a location for the card reader that meets the following constraints The distance between the card reader and the Polyx NF door controller is less then 120 meter There is at le...

Page 2: ...AT5 UTP or CAT6 UTP network cable with RJ45 T 568B connectors to connect the card reader to the Polyx NF Plug the RJ45 connector of one end of the cable in port Reader 1 or Reader 2 of the Polyx NF Cut off the RJ45 from the other end of the network cable Remove the isolation and untwist the wires Combine the orange and green wires and connect them to pin 1 A Combine the white orange and white gree...

Page 3: ...resent your access card to the reader The LED will start blinking red green slowly Enter your pincode The LED will start blinking red green quickly When the intrusion alarm is armed correctly the LED starts blinking red green slowly Tip When entering your PIN code remove your finger at least 1 cm from the panel between each digit Technical data Interface RS485 Polyx NF Supported cards Mifare 1K Mi...

Page 4: ...ng temperature 31º to 150º F 35º to 65º C Storage temperature 67º to 185º F 55º to 85º C Operating humidity 5 to 95 relative humidity non condensing Transmit frequency 13 56 MHz Standard ISO14443 A Indicators 2x RGB LED and 1 buzzer Connection 7 pin screw connector Certifications CE ...

Reviews: