background image

 

FORM FIT

 

HOOD PROTECTOR 

 

  

Volkswagen Golf 3-Door / 5-Door / GTI / Wagon  2010 -                                          

   

HD 21L 10 

 

 

HARDWARE KIT 

 

TOOLS REQUIRED   

 

5 – Large Bumpons 

 

 

 

 

 

             1 – Phillips Screwdriver # 2 

4 – 3M Anti-Abrasion Film Pads 

 

 

 

 

             1 – Tape Measure 

4 – Clip Bodies 

 

4 – ‘L’ Brackets 
4 – Pins 
4 – #6 x 5/8” Truss Head Screws 

 

1. 

Be sure that the hood is clean and dry inside and out. Release the hood, but do not open it. 

2. 

Install the bumpons as shown in Illustration #1. 

Attention: The bumpons must be installed on the hood, not on the protector!!!

 If the 

bumpons are installed on the protector, they will wear through the paint. 

3. 

Center the protector on the hood, resting on the bumpons. 

4. 

Peel and fold an anti-abrasion film pad in half over the edge of the hood underneath each of the two (2) inner holes in the protector. See 
Illustrations #1 & #2 

– Step #4

 

5. a) Place a clip over each of the anti-abrasion film pads on the edge of the hood as shown below in 

Illustration #2 – Step #5a

b) Insert a pin through the protector into each of the clips.  

See Illustration #2 – Step #5b.

 

c) Insert a #6 x 5/8’’ screw through an ‘L’- bracket and into the clip. 

See Illustration #2 – Step #5c & 5d. 

d) Make sure all the components are well seated together; the protector is centered on the hood, and then tighten the screws into the clips. 

6. 

Repeat steps #4 and #5for the other two (2) holes.

 

  

7. 

On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance. 

Note: Do not pull on the protector when opening or closing the hood.

 

 

 
CARE INSTRUCTIONS 

Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents

.  Periodically check to 

make sure the bumpons are in place and the protector is secure.  

Avoid using automatic car washes

.  Do not pull on protector when opening or 

closing the hood.              

     

Illustration 

#1 

– 

Bumpon 

and 

Clip 

Location 

         

  

 

 

Clips (Steps #4 and #5) 

 

  Clips (Step #6) 

          

 

80mm      

25mm 

370mm 

180m

110mm 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

       

 

Illustration #2 – Clip Configuration – Patent No. 6,892,427 

 

 

 

 

 

 

 

 

 

 

Step #4 

Step #5a 

Step #5b 

Step #5c & 5d 

 
 
 

 

 
 
 
 
 
 

 

 
 

Thank you for purchasing a 

form fit

 hood protector. Retain this sheet for care instructions and kit information 

Made in Canada

 

  Rev0.100323

 

 

Reviews: