Rev0.Oct 21, 2015
Page
1
of
6
Hardware Kit
Tools Required
4
– Adhesive Backed Pedestals
2
– Abrasion pad
1
– Phillips Screwdriver #2
4
– Square Expansion Plugs
2
– Mounting clips
1
– Tape Measure
4
– #8 x 9/16” Black Screws
2
– Pins
1
– Masking Tape and Pencil
4
– Square bumpons
2
– ‘L’ Brackets
1
– Soft cloth or paper towel
2
– Automotive surface cleaner
2
– #6 x 5/8” Flat Head Screws
1
– Repositionable tape strips
2
– Round bumpons
1
– “D” gasket (55”)
Installation
1.
Ensure the hood is clean and dry.
2.
Locate the center
of the hood
using the body line as a reference. Place a piece of masking tape on top of the grill near center, where
the grill meets the painted surface of the hood. Mark the masking tape with a pencil at the center.
See Illustration.
3.
Place four (4) additional pieces of masking tape on the grill to mark the location of the adhesive backed pedestals. Mark the masking tape
with a pencil at the location as shown.
5.
Temporarily tape the pedestals to surface of the hood in their determined positions. Confirm correct placement by placing the hood
protector on top of the four pedestals. When positioned correctly the four (4) holes in the center area of the protector will align with the
holes in the expansion plugs. Adjust if necessary and reconfirm the pedestal locations using the measurements in the illustration and
the hood protector.
4. Install the square expansion plugs into the top of the adhesive backed pedestals. Use the centering notch on the pedestals to align
it
’s location with the pencil mark on the tape from the previous Step.
Note:
When located correctly the leading edge of the pedestal
will butt against the back of the grill.
FORM FIT
Hood Protector
HD 5M08
Installation Instructions
Chevrolet Silverado 2500 2008-14
