3M Primer 94 Instructions
-Squeeze tube in middle to break inner ampule
-Apply to clean, dry surface
-Allow at least 5 minutes to dry before taping
HARDWARE KIT
TOOLS REQUIRED
3M Double-sided Body Moulding Tape
None
- already applied to the deflector
2
– Alcohol Wiping Pads
2
– 3M Adhesive Promoters
4
– Pedestal Clips with tape applied
Attention
: This product uses a 3M adhesive product that requires installation and curing temperatures of at least 20°C/ 70°F for 24 hours to develop
maximum adhesion to the surface.
Failure to install this product at the proper temperature or allow adequate curing time before use is not
covered under warranty.
1.
The deflectors mount to the window frames of the doors. Make sure that those areas are clean and dry.
2.
Start
with the Passenger’s side front door of the car.
3.
To understand how the deflector will fit, place the
front Passenger’s door deflector up to the car. Align the end of the deflector with the edge of the
door as shown below. The top edge of the deflector runs flush along the top edge of the window frame.
4.
Clean the contact area of the window frames with alcohol wiping pad. Allow to dry.
Note: The next step requires mandatory use of adhesion promoter; failure to follow all installation steps is not covered under warranty.
5.
Prime the contact area on the window frame with the adhesive promoter.
6.
Peel the protective backing from the tape starting at the end as shown, peel only the first 30-40 cm (12-15 inches) of the protective backing from the
tape on the flange of the deflector. Press the deflector into place as determined above. Work forward, removing the protective backing from the tape
and pressing the part into place.
7.
Once the deflector is in place press down
hard
along the entire flange area to make sure that the tape is fully adhered to the vehicle.
8.
Peel, clip and adhere a pedestal clip into place as shown below. Once in position pinch the taped area firmly against the window frame to ensure full
contact of the tape.
9.
Repeat steps 3-8 for the remaining deflectors. When installing the rear door deflectors, start at the front end of the door and work back.
Be sure
to
allow a gap between the front and rear deflectors similar to the gap between the doors.
CARE INSTRUCTIONS
Clean the deflectors with a mild soap and water solution or plastic cleaner only.
Do not use chemicals or solvents
. Periodically check to
make sure the deflectors are secure.
Avoid using automatic car washes
.
ILLUSTRATION
– SIDE VIEW, ALIGNMENT
Thank you for purchasing
side window visors.
Retain sheet for Care Instructions and Kit Information.
SD 13R07-5 Rev0.Jan 5, 2018
1/8
– 1/4” Gap to
Match Door Gap
Align and start here
Deflector
Tape
Door
Clip
Tape
Side Window Visors
Installation Instructions
SD 13R07-5
Nissan Versa 5-Door 2007-2012
Fenêtre côté visières
SD 13R07-5
