For more information,
consult the Instructions
for Use Manual or call
888.818.6777.
©2014 Freedom Innovations, LLC. All rights reserved. Plié® 3 MPC Knee is a trademark of Freedom Innovations, LLC.
R-720-192 Plié® 3 MPC Knee Owners Guide, Rev. A
FREEDOM INNOVATIONS
Global Headquarters
3 Morgan
Irvine CA 92618
toll-free 888.818.6777
tel 949.672.0032
www.freedom-innovations.com
Warranty and Service
The Plié 3 MPC Knee has a 36 month warranty and includes
two service intervals, 12 and 24 months after purchase. Service
is required to maintain warranty validity. Your prosthetist will
contact you to schedule an appointment when it is time to
receive knee service. You will be provided with a loaner knee
unit while your knee receives service.
Care & Use
The Plié 3 MPC Knee is safe for occasional submersion in fresh
water up to 1m (3 ft) for up to 30 minutes. You should dry the
knee with a towel once out of the water. The Plié 3 MPC Knee
should not be immersed in saltwater or chlorinated water as
these may cause corrosion. Failure to comply will void the
warranty.
If unintentionally exposed to chlorinated and/or salt water
environments, the knee should be rinsed with fresh water.
While the Plié 3 MPC Knee withstands moist environments,
excessive use in wet conditions may result in corrosion and/
or undesirable operational noise. If the knee requires general
cleaning, wipe the outside surfaces with a cloth and rubbing
alcohol. For further information about how to care for you Plié
3 MPC knee, please contact your prosthetist
If the Plié 3 MPC Knee is physically damaged or
does not function properly, immediately contact
your prosthetist.
Focused Solutions
Freedom Innovations is solely focused on developing world-class lower limb solutions
in close collaboration with amputees and prosthetists. These solutions encompass
technological innovations, service, training and educational resources, together with
consultative support, to help ensure user satisfaction
•
High elevations and cold temperatures will affect the knee’s internal air pressure. In
these conditions, you may be required to increase the air pressure to resume normal
function.
•
Without power, the Plié 3 MPC Knee will not release into swing phase. In this
powered-down mode, the knee will default to the stance flexion resistance setting.
Insert a charged battery to resume normal knee function.
•
Use only the batteries and battery charger intended for use with the Plié 3 MPC Knee.
•
During repetitive activities without swing phase, such as the use of exercise
equipment, turn the stance flexion resistance setting counterclockwise to the
“Off” position with a 4 mm allen key. After the activity, adjust the stance flexion
resistance to its previous setting.
Owner’s
Guide
MICROPROCeSSOR Knee
Plié3 Owner’s
Guide
