Installation Instructions
WALL SLEEVE
For Use With Packaged Terminal Units
Please read these instructions completely before attempting installation.
NOTE: These instructions apply to installation of the wall sleeve only through walls structurally adequate to support the unit
(i.e. sleeve, chassis, accessories.) If wall is not structurally adequate, a subbase or other means of support MUST be made.
Model PDXWS
Wall Opening
Refer to
Figures 1 and 2
for proper dimensions and
location of wall opening and placement of electrical
receptacle.
WARNING
Electrical shock hazard.
Turn OFF electric power at fuse box or service panel
before making any electrical connections and ensure a
proper ground connection is made before connecting
line voltage.
Failure to do so can result in property damage,
personal injury and/or death.
16¼"
50"
Maximum
10" Maximum
Electrical
Receptacle
Smooth side of
clip on Room side.
Insulation
42¼"
Minim
um
Lintel Used To Support
Masonry Walls
Electrical
Receptacle
13¾"
W
all Opening
Figure 1.
Typical Wall Sleeve Installation
920-078-01 (12-04)
