Drawing not to Scale
Wall Outlet
M
IDDLE SECTION
B
B
OTTOM SECTION
C
R
EMOTE CONTROL
and
PLUG-IN REMOTE
CONTROL RECEIVER
L
EGS
SET IN
X
SHAPE
T
OP SECTION
A
PARTS LIST
A. TOP
B. MIDDLE
C. BOTTOM
HARDWARE
A. TREE STAND
QUANTITY 1 PC
B. 1/4” SCREWS FOR TREE STAND
QUANTITY 5 PCS
C. POWER STRIP
QUANTITY 1 PC
D.
E. PINE CONE ORNAMENT
REMOTE CONTROL W/ RECEIVER
QUANTITY 1 SET
QUANTITY 2 PCS
7.5’ FRASER FIR TREE - ITEM #33027
Step 1
Pull apart the legs of the stand so that they are “X” shaped.
Fasten the bottom screws to lock the stand into position.
Step 2
Insert the section (C) of the tree into the stand and tighten
screws on base to secure tree pole.
Step 3
Plug light set of (C) into power strip, plug power strip into
remote control receiver. Then, plug remote control receiver
into wall outlet.
Step 4
To shape your tree, start with the bottom most layer of
branches, with each branch start with the tips closest to the
pole and lift each tip up and out in alternating directions.
Repeat for each branch. It is recommended to shape section
(C) before adding section (B).
Step 5
Insert the section (B) of the tree into the section (C) of the
tree. Plug light set of (B) into power strip and repeat steps 4
and 5 for shaping.
Step 6
Insert the section (A) of the tree into the section (B) of the
tree. Plug light set of (A) into the section (B).
Step 7
To shape the top of the tree it will be necessary to gently bend
the branches downward to the desired angle before shaping
the tips.
SKU 33027 - 7.5’ FRASER FIR TREE
5794 TIPS
METAL STAND
UL 1200 LIGHTS
MAX DIAMETER 63”
NUMBER OF PERSONS
RECOMMENDED FOR
ASSEMBLY: 2
ASSEMBLY INSTRUCTIONS
