STRONG. SIMPLE. COMPACT.
800.285.6780 sales@ggled.net
Rev Date 23 0610
IP69K
IP68
CERTIFIED
IK10
IMPACT
C E R T I F I E D
EDGE
INSTALLATION MANUAL PAGE 1
WARNING
Fixtures must be installed by a qualified electrician in accordance with all applicable national and local electrical
and construction codes and regulations. Please read through this entire document before beginning the
installation.
Remove any fixture from service if water or corrosion is observed inside the fixture. Water and chemicals can
corrode metallic components and damage electrical circuits. Faulted electrical circuits can experience self-
heating which, while unlikely, may present a fire hazard if left unchecked. This heating can also serve as an
ignition source for gasses generated by the corrosion of metals inside of the enclosure. Regularly scheduled
inspections are recommended to ensure safe operation.
RISK OF ELECTRIC SHOCK
•
Turn power off before inspection, installation, or removal.
Electrical Requirements
•
Suitable for wet locations.
•
Follow all National Electric Codes (NEC) and local codes.
Notes
These instructions cover both the standard EDGE Power/Data Translator (PDT) configuration and PDT
configuration that includes the optional ColorWash controller. The steps which differ between these two
configurations are in separate sections, and it is only necessary to complete the ones that apply to the PDT
being installed.
Customer Service
For technical assistance and installation support please call 800-285-6780 x2 or email support@ggled.net
