OPERATION
1. Press the POWER button to turn the hair processor ON/OFF.
2. Adjust the TIME to the appropriate setting.
By default, the timer is set at 15min.
a. (+) increase time
b. (-) decrease time
3. Adjust the TEMPERATURE to the appropriate setting.
By default, the temperature is set to the lowest setting.
Press the button located below the temperature gauge to increase/decrease the temperature.
4. Adjust the FAN SPEED to the appropriate setting. There are 3 fan speeds:
a. LO - LOW
b. MED - MEDIUM
c.
HI
– HIGH
5. Press the INFRARED button to activate the infrared function.
When the infrared function is in use, the indicator lamp will be lit.
6. Press the OZONE button to activate the ozone function.
When the ozone function is in use, the indicator lamp will be lit.
7. Once you have selected your desired settings, press START/STOP to begin processing.
a. To stop processing before the set time or to delete previous settings,
press the START/STOP button.
b. Please allow the hair processor 5-10 seconds to come to full fan speed.
CONTROL PANEL
PARAGON
®
E-3000 HAIR PROCESSOR
Before installing and using this unit, please carefully
read these instructions. Be sure to keep this
available for later reference.
N O T E
REFERENCE CHART IS A GUIDE ONLY. PLEASE CONSULT WITH COLOR/ PERM
MANUFACTURER
’S DIRECTIONS. DO NOT EXCEED MANUFACTURERS’ DIRECTIONS.
REFERENCE CHART IS A GUIDE FOR MEDIUM HAIR LENGTH WITH NORMAL
POROSITY AND NORMAL ELASTICITY.
TEST HAIR FOR TEXTURE, DENSITY, POROSITY, AND ELASTICITY BEFORE
COMMENCING PROCESSING.
