Fusion
®
XS Series Marine Wake Tower Speakers Installation
Instructions
Important Safety Information
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other
important information.
This device must be installed according to these instructions.
Disconnect the vehicle's or vessel's power supply before beginning to install this device.
CAUTION
Continuous exposure to sound pressure levels over 100 dBA may cause permanent hearing loss. The volume is
typically too loud if you cannot hear people speaking around you. Limit the amount of time you listen at high
volume. If you experience ringing in your ears or muffled speech, stop listening and have your hearing checked.
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
It is strongly recommended that you have your audio system installed by a professional installer to ensure
optimum performance.
You must read all installation instructions before beginning the installation. If you experience difficulty during
the installation, go to
What's In the Box
• Two wake tower can speakers
Materials and Tools Needed
• 16 AWG (1.31 mm
2
) wire (speakers) (
Speaker Wire Gauge Guide, page 2
)
• 20 AWG (0.5 mm
2
) wire (LEDs)
• 3 A in-line fuse (LEDs)
• Speaker mounting bracket (sold separately)
1
• Drill and 12 mm (
1
/
2
in.) drill bit
• Wire strippers
• Solder and dual-wall heat-shrink tubing for wire connections
NOTE: For customized installations, additional tools and materials may be needed.
1
Various brackets are available for mounting these speakers on a wake tower bar or on a deck. See your Fusion dealer for more information.
GUID-779EF88A-1B57-4670-8074-539F3565BD19 v2
May 2021
