Marine Mount
Instructions
WARNING
See the
Important Safety and Product
Information
guide in the GPS device
product box for product warnings and
other important information.
Garmin
®
strongly recommends having an
experienced installer with the proper
knowledge of electrical systems install the
device. Incorrectly wiring the power cable
can result in damage to the vehicle or the
battery and can cause bodily injury.
CAUTION
Always wear safety goggles, ear
protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
The metal contacts on the GPS device
and the mount should be kept dry to avoid
equipment damage. Use the weather cap
on the mount at all times when the unit is
not mounted to keep the metal contacts
dry and protected.
To obtain the best performance and to
avoid damage to your boat, install the
device according to these instructions.
Read all installation instructions before
proceeding with the installation. If you
experience difficulty during the installation,
contact Garmin Product Support.
Tools Needed
• Drill
• Phillips screwdriver
• 9.5 mm (
3
/
8
in.) wrench or socket
• 3 bolts or 3 screws:
◦
#8 (4 mm) pan-head machine bolts
with nuts and washers, and a
5 mm (
1
/
16
in.) drill bit
◦
#8 (4 mm) pan-head self-tapping
screws and a 1.5 mm (
1
/
16
in.) drill
bit
Mounting Considerations
NOTICE
The swivel base must be mounted using
pan-head machine bolts or self-tapping
screws. Using screws with countersunk
heads can damage the mounting bracket.
DRAFT
A
ng an
an
oper
ms install the
ms install the
he power cable
he power cable
the vehicle or the
the vehicle or the
se bodily injury.
dily injury.
DR
DR
D
D
CAUTION
safety goggles, ear
safety goggles, e
a dust mask whe
a dust mask wh
D
D
CE
all
all
ng with th
ng wi
ience difficulty d
ience diff
ntact
ntact
Garmin Product
min Pr
Tools Needed
Tools Needed
• Drill
• Drill
• Phillips sc
Phil
• 9.5 mm
• 9.5 m
• 3 b
3 b
Summary of Contents for Marine Mount
Page 6: ...D R A F T ...
Page 7: ...D R A F T ...
