background image

     When used in high temperature areas, such as the beach during summer or in a hot room, the 

     internal pressure of the canister may rise to more than 71psi~85psi 

 This will activate the Automatic Safety Shut-off Device inside the regulator.

Important: Read these instructions for use carefully.

Familiarize yourself with the appliance before connecting

it to its gas container. Keep these instructions for future reference.

If you smell gas:
1. Do not attempt to light appliance.

2. Extinguish any open flame.

3. Disconnect from fuel supply.

4. Evacuate area, call for professional

     help.

FOR YOUR SAFETY

Do not store or use gasoline or other 

liquids with flammable vapours in the

vicinity of this or any other appliance.
This stove is equipped for use with 

butane gas only. Do not attempt to 

operate this stove at temperatures 

below freezing (32 degrees F).

FOR YOUR SAFETY

Model GS-800P

FOR OUTDOOR USE AS A CAMPSTOVE. 

NOT FOR HOUSEHOLD USE.

MODEL GS-800P PORTABLE BUTANE STOVE

INSTRUCTION MANUAL

LIGHTING THE STOVE

TO ADJUST HEAT

EXTINGUISHING

AFTER USE

(Fig.4)

(Fig.5)

THE OPENINGS AT THE BASE OF THE BURNER PROVIDE AIR FOR COMBUSTION, THEY 

SHOULD NEVER BE OBSTRUCTED. IF THE FLAME BECOMES SIGNIFICANTLY ORANGE CHECK

THESE OPENINGS FOR A BLOCKAGE. 

IF THE APPLIANCE CANNOT BE ADJUSTED TO PERFORM CORRECTLY IT SHOULD NOT BE 

USED UNTIL SERVICED OR REPAIRED. 

WARNING

BEFORE LIGHTING THE COOKER, ALWAYS ENSURE THAT THE PAN SUPPORT/DRIP TRAY 

HAS BEEN PLACED IN THE UPRIGHT AND CORRECT POSITION. 

Operating this appliance with the pan support in the down(storage/transportation)

position will cause the appliance to overheat and possibly explode.

WARNING

NOTE: Close the Canister Cover before lighting. Not closing the cover can cause the canister

to overheat.

Turn the Control Knob counterclockwise until you hear a click indicating that 

a spark has been produced.(Fig.4)
If the stove does not light, turn the Control Knob back to the OFF position 

and repeat.
If after three failed attempts, the stove does not light, turn the Control Knob to the "OFF"

position and move the canister lever to the "UNLOCK" position.
Open the canister cover and remove the canister. Shake the canister to see if it is empty.

If empty, replace the canister and begin from Fig.1

Flame can be controlled by turning the Ignition Knob between the ‘IGNITION’ and ‘OFF’ position.  

1. Turn the Ignition Knob to ‘OFF’ to shut off fuel supply (Fig. 5).  Wait until the flame

     is fully extinguished before performing the next step.   

 

 

2. Raise the Canister Lock Lever to ‘UNLOCK’ and remove the gas canister from 

     the compartment. (Fig.1)

 

Note: Do not leave the gas canister inside the unit when not in use. 

   

1. Replace the cap on the gas canister after removing it from the unit. Store upright in a cool 

     dry place. 

2. Make sure the burner is cool to touch before packing unit away.

THE AUTOMATIC SAFETY SHUT-OFF DEVICE ACTIVATION 

   

(normal pressure = 

28psi~43psi). 

 

 

Turn the Ignition Knob to ‘IGNITION’ to release any excess gas inside the regulator.  

Repeat the 3 steps for inserting the gas canister after it has cooled down. 

Remove the Gas Canister from the compartment.  

If the stove had been in use and was working properly. the butane can should be cold to the

touch. If it is not and feels warm, go back to the "Precautions" on the Stove Use section and

confirm if you are using the stove correctly.

NAME OF PARTS

IMPORTANT

IT MAY BE HAZARDOUS TO ATTEMPT TO FIT OTHER TYPES OF GAS CONTAINERS.

* REMOVE ANY TRANSIT PROTECTION MATERIAL.

(Fig.3)

(Fig.2)

NOTE: If the gas canister is not connected correctly, you will hear a hissing sound. 

If you hear a hissing sound, check for any leaks by using soapy water. 

Never use a flame. Bubbles would indicate a gas leak.

FITTING THE GAS CANISTER

1. Make sure the Canister Locking Lever is in the "UNLOCK" position or the 

     gas canister can not be installed.

Make sure the Control Konb is turned all the way clockwise to the "OFF" 

position.(Fig.1)

(Fig.1)

2. Open the Gas Canister Cover and insert the canister so that the regulator 

     guide is aligned with the notch in the canister rim. (Fig.2)

3. Push down on the Canister Lever to the "FUEL LOCK" position.(Fig.3)

CAUTION: When connecting or disconnecting the gas canister, be sure that 

no external sources of ignition are present.

 

 

 

Check that the seals between the appliance and the gas canister are in place and in good condition 

before connecting the gas canister.  

DO NOT use this appliance if it has damaged or worn seals. 

DO NOT use this appliance if it is leaking, damaged or does not operate properly. 

Canister holder

Safety guide

MINI STOVE

IGNITION

OFF

UNLOCK

LOCK

Notch

MINI STOVE

IGNITION

OFF

UNLOCK

LOCK

MINI STOVE

MINI STOVE

IGNITION

OFF

UNLOCK

LOCK

CARBON  MONOXIDE  HAZARD

This appliance can produce carbon monoxide

which has no odor.

Using it in an enclosed space can kill you.

Never use this appliance in an enclosed space

such as a camper, tent, car or home.

WARNING

Igniter

Drip Pan

Burn Head

Windshield

Canister Cover

Pan Supports

Canister Locking Lever

Control/

Igition Knob

This portable gas stove shall be used with 227g (8 Oz.) GASONE Model GAS-1 non-refillable fuel  

gas canister. 

WARNING

BEFORE INSERTING A CANISTER, ALWAYS ENSURE THAT THE PAN SUPPORT/DRIP 

TRAY HAS BEEN PLACED IN THE UPRIGHT AND CORRECT POSITION.

USE OF THE APPLIANCE WITH BUTANE CANISTER

8 oz. Butane

16.4 oz. Propane

GAS    ONE

 

 

 

Summary of Contents for GS-800P







Reviews: