For answers to your Monogram,
®
GE Profile
™
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
JP626WK/CK/BK
GE
®
36" Built-In Electric Cooktop
Specification Revised 4/06
321350
Listed by
Underwriters
Laboratories
Electrical junction box 16" MIN.
below countertop
30" MIN. to
unprotected
cabinet
Cut should
not interfere
with cabinet
structure
at front
3-3/4"
clearance to
side wall
from cut-out
3-3/4"
clearance to
side wall
from cut-out
18" MIN.
to cabinet
2-1/2" to
rear wall
13" MAX.
depth
Cooktop
2-1/2"
(min.)
33-7/8"
19-1/8"
35-1/2"
21
3
Note: Check local codes for required breaker size
Important: Maintain 5" (12.7 cm) minimum
vertical clearance between the cooktop bottom
and any combustible surfaces.
Clearance not required when installing wall
oven underneath. Requires an 18” minimum
from cooktop to adjacent overhead cabinets.
Units are furnished with a 48” flexible
armored cable.
JP626 is approved for use over GE 30” Single Wall Ovens only. Refer to
cooktop and wall oven installation instructions packed with product for
current dimensional data.
If installed with a
GE Telescopic Downdraft System, consult both
cooktop and downdraft installation instructions packed with product
before installing. Cooktop gas/electric supply may need to be re-routed
to install downdraft.
The countertop must be at least 26” deep with a flat surface area of
23-1/2” or more, front to back. In addition, other clearances to the front
edge of the countertop must be considered.
This cooktop
cannot be installed in countertops that cannot accept
screws, such as granite or marble, etc.
Installation Information: Before installing, consult installation instructions
packed with product for current dimensional data.
KW Rating
240V
7.4
208V
5.6
Breaker Size
240V
40 Amps
†
208V
30 Amps
†
Dimensions and Installation Information (in inches)
5" (12.7 cm) Min.
Vertical Clearance
